PGST PE-520R Wireless Standalone Alarm Siren User Manual
- June 9, 2024
- PGST
Table of Contents
PGST PE-520R Wireless Standalone Alarm Siren
Product Overview
Solar wireless siren uses solar energy to power the built-in battery, to control signal by wireless or wired transmission which enhance the flexibility of installation. You can build multiple wireless sirens at different locations to get alarms simultaneously to alert illegal intruders.
The wireless siren can be used as a live alarm system. First choose the wireless accessories with the same working frequency as the siren according to the system’s demand, then code and learn the accessories into siren, thus an independent alarm on the spot comes into being.
Wireless siren should be installed where’s the best for precaution as well as the best reception for all wireless detectors. Pay attention that the siren should be as far as possible from the large metal objects or household appliances with high-frequency interference; meanwhile, to avoid the shields of ferroconcrete wall and fire-proof door.
PCB diagram
Function Setting by jumper
Siren alarm sound setting
Delay alarm time setting
Work as a wired siren
This Solar siren easily connects to alarm panel by its two wired defense zones
Zo &Z1. The siren will sound and flash when the alarm panel makes alarms
.
Work As wireless siren
Solar siren needs coding with wireless alarm panel which have wireless
transmission module, then it makes sounds and flashes when there is an alarm
from the alarm panel To connect alarm panel: press setting key to make out a
“beep, siren into coding state; then trigger the panel to release a wireless
signal, coding successfully when you hear two “beeps”.
Work as live alarm system
How to code the remotes and detectors:
Press setting key to make a “beep”, siren into coding state, then trigger the
remotes or detectors, coding successfully when you hear two “beeps”.
Delete all remotes, detectors and alarm panel
Press setting keys till make two “beeps”, release the setting key to delete
successfully.
Alarm status
- Arm state: In this state, all detectors can trigger it alarm.
- Disarm state: In this state, none detector can trigger it alarm.
- Alarm state: In this state, the siren alarm by sound and flash on spot. It will exit alarm automatically after 3 minutes if no operation, return to standby state.
Daily operation
- Arm: press [ ]or [ ] key( or ).
- Disarm: press [ ]key
- Emergency alarm: press [ sos ] key .
Arm
Arm means the standalone alarm carry out all alert deployment: when no
one at home, you need to place a comprehensive detection alert with the alarms
on prevention spots,ensure all detectors are in working condition; when probe
source (thief intrusion, fire broke out, gas leak etc.) trigger the detector,
the alarm system give an alarm immediately Remote operation: press remote
control [ ] key once.
Standalone alarm disarm
Standalone alarm disarm means to let the alarms in a state of non-alert. One
disarm is the normal dis arm operation after arm it; another disarm is, you
need to stop this alarm while after its alarming: The normal zone will not
work after disarmed, excpet for 24-hour zones Remote operation: press remote
control [ ]button once.
SOS
Some special cases occur at home, sudden illness for the elderly or children
results in first aid;in case of sudden fire, help is needed; criminals
burglary muggings,at such situations, you could press [sos] button or
wireless emergency button alarm.lt will immediately give an alarm, tell the
host family. Remote operation: press remote control | sos] once.
Installation
- Fix the bracket with screws onto the wall .
- Put the siren on the bracket .
Technical parameter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>