Westfalia 92 29 05 One Touch Automatic Can Opener Instruction Manual

One Touch Automatic Can Opener
Art. 92 29 05
Original Instructions

92 29 05 One Touch Automatic Can Opener

Dear Customers,
Instruction manuals provide valuable hints for using your new device. They enable you to use all functions, and they help you avoid misunderstandings and prevent damage. Please take the time to read this manual carefully and keep it for future reference.
If you pass the device on to third parties, enclose these instructions.

SAFETY NOTES

Please note the included General Safety Notes and the following safety notes to avoid malfunctions, damage or physical injury:

• Please read this manual carefully and use the device only according to this manual.

• Dispose of used packaging material carefully or store it out of the reach of children. There is a danger of suffocation!

• Persons with limited physical, sensorial or mental abilities are not allowed to use the device, unless they are supervised and briefed for their safety by a qualified person.

• Close supervision is necessary when the can opener is used by or near children. Ensure that they do not play with the can opener. It is not a toy.

• Do not open pressurized (aerosol-type) cans.

• Do not open cans of flammable liquids such as lighter fluids.

• Make sure the motor has stopped completely before lifting up the battery door for battery replacement.

• Avoid contact with moving parts. Keep hands, hair, jewellery, clothing etc.
  away from moving parts during operation to prevent injury and/or damage to the can opener.

• Do not immerse the can opener in water or any other liquids.

• Do not try to adjust or remove the cutter screw.

• Do not clean the appliance in the dishwasher.

• Use only batteries of the same type.

• If you do not plan to use the appliance for some time, remove the batteries.

• Do not disassemble, burn or short-circuit batteries and do not attempt to recharge non-rechargeable batteries.

• Should the appliance become damaged, do not use it and have it repaired by a professional or contact our customer service. Do not disassemble the appliance or try repairing it yourself.

Operation

Battery Installation

1. Press and hold both sides of the battery door (2). Pull it backward and then lift it upward (see figure A).
2. Remove the old batteries and install 2 new alkaline batteries or rechargeable batteries of the type LR6 (AA) into the battery compartment (3). Pay attention to the proper polarity of the batteries. The polarity is marked on the housing of the device.
3. Replace the battery door and close it after the batteries have been installed.
4. Always replace both batteries at the same time. Never mix old and new batteries or batteries of different types.
   Note: The cutter will not operate when either the battery door or the front cap are removed from the unit.

Using the Can Opener

1. Place the can opener on top of the can with its rim positioned in the groove at the bottom of the can opener (see fig. B). Notes: The cutter will not operate unless it is positioned properly on the rim of the can. To open cans with tab, turn them upside-down, so that the can opener can work on the lid without tab.
2. With the can on a flat surface, press the start button (1) for about one second and release it once the can opener starts to cut the can (see fig. C). After cutting, the can opener will stop automatically (see fig. D). Note: The maximum can size that can be fully cut in one cycle is 98 mm diameter. If you need to completely remove the lid of a bigger can, press the start button again and the can opener will resume cutting and stop automatically after cutting.
3. When cutting is completed, lift the can opener off the can. A magnet (9) on the can opener will pick up the lid for your convenience (see fig. E). Note: There is a functional sharp edge on the round cutter. It should be treated with care.

Maintenance and Care

1. If the can opener slows during cutting, this may indicate a low battery level and the batteries should be replaced. If the can opener stops during operation, refer to the
   chapter Trouble Shooting.

2. To clean the cutter, first push back the battery door (2). The remove the front cap (5) (see fig. F). Wipe the cutter with a damp cloth or a sponge using a mild non-abrasive cleaner, followed by a clean and dry cloth and dry it completely. Replace the front cap and the battery door after cleaning.
   Note: The front cap cannot be removed without pushing back the battery door as they are interlocked.

Troubleshooting

1. If the can opener is jammed due to low battery level or a deformed can rim, press and hold the reverse switch (4) at the rear of the can opener. The can opener will move in
   the reverse direction and release the can.
   Keep the reverse switch pressed until the can opener stops (see fig. G).

2. If batteries are empty, the can opener may not be released by pressing the reverse switch. In this case, replace the batteries with a new set of batteries.
   Caution! The can opener will automatically resume cutting when the battery door has been closed.

3. Cans with heavy seams, odd shapes or uneven rims may stall the can opener.
   If this happens, follow above procedure to release the can. Start the cutting action just beyond any minor bump or dent in a can.
   Note: The can opener will not open rimless cans or cans with odd corners.

Technical Data

Model: One Touch Automatic Can Opener
Operating Voltage: 3 V
Batteries: 2x LR6 (AA) alkaline or rechargeable Batteries
Nominal Power: 3 W
Max. can cutting size: Ø 52 – 153 mm
Max. can cutting size in one cycle: Ø 98 mm

| Batteries do not belong in the household garbage.
For battery disposal please check with your local council.|
---|---|---

EU DECLARATION OF CONFORMITY

We, the Westfalia Werkzeugcompany, Werkzeugstraße 1, D-58093 Hagen, declare by our own responsibility that the product
One Touch Automatic Can Opener
Article No. 92 29 05
is according to the basic requirements, which are defined in the European Directives and their amendments.
2011/65/EU
Restriction of the Use of certain hazardous Substances in electrical and electronic Equipment (RoHS)
2014/30/EU
Electromagnetic Compatibility (EMC) EN IEC 55014-1:2021, EN IEC 55014-2:2021
The technical documentations are on file at the QA department of the Westfalia Werkzeugcompany.
Hagen, 6 thof January 2023

CUSTOMER SERVICES

DEUTSCHLAND
Westfalia
Werkzeugstraße 1
D-58093 Hagen
Telefon: (0180) 5 30 31 32
Telefax: (0180) 5 30 31 30
Internet: www.westfalia.de| SCHWEIZ
Westfalia
Wydenhof 3a
CH-3422 Kirchberg (BE)
Telefon: (034) 4 13 80 00
Telefax: (034) 4 13 80 01
Internet: www.westfalia-versand.ch| ÖSTERREICH
Westfalia
Moosham 31
A-4943 Geinberg OÖ
Telefon: (07723) 4 27 59 54
Telefax: (07723) 4 27 59 23
Internet: www.westfalia-versand.at
---|---|---

DISPOSAL

Dear Customer,
Please help avoid waste materials.
If you at some point intend to dispose of this article, then please keep in mind that many of its components consist of valuable materials, which can be recycled. Please do not discharge it in the rubbish bin, but check with your local council for recycling facilities in your area.
Gestaltung urheberrechtlich geschützt
©Westfalia 01/23

Documents / Resources

| Westfalia 92 29 05 One Touch Automatic Can Opener [pdf] Instruction Manual
92 29 05 One Touch Automatic Can Opener, 92 29 05, One Touch Automatic Can Opener, Touch Automatic Can Opener, Automatic Can Opener, Can Opener, Opener
---|---

References

• Westfalia Versand Österreich | Werkzeug ✓ Garten ✓ Technik ✓ & mehr
• Westfalia Versand Schweiz | Werkzeug ✓ Garten ✓ Technik ✓ & mehr
• Westfalia Versand Deutschland | Werkzeug ✓ Garten ✓ Technik ✓ & mehr

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>