SolarGoesGreen SGG-S12-Flag Solar Light User Manual

Table of Contents

The SGG-S12-FLAG is designed as a stand-alone spotlight that automatically illuminates at dusk.
It is completely solar-powered and must be installed in a position where the solar panel will receive the maximum sun per day.
It is energy-saving, auto switches on/off, and has an appealing design.
The unit has a single spotlight with 12 super bright LEDs and a Li-ion rechargeable battery which is easily replaceable.
The SGG-S12-FLAG can easily be installed and used in a broad range of applications such as gardens, yards, walls, signs, flags, etc.

Take off the connection part of the LED lamp(Fig.9)
Fix lamp to pole mount base by using screws provided.
Mount Solar Panel to pole mount base using provided butterfly nut (Fig.10).Adjust lamp initial aiming direction before fixing it.
Fix the pole light unit to flagpole by using stainless steel clamps. There are varied sizes of clamps suitable for smaller size of flagpole. (Fig.11)
After installation, connect Spotlight wire with Solar panel wire and switch the unit on the solar panel. The light will automatically be operational when the panel detects that it is dark enough.

If there is not enough sunlight on the solar panel, the unit may not charge, please ensure that the unit is placed in a position where there is at least 8-10 hours of sunlight a day.
If there is too much ambient light, the unit will not activate as it will assume that it is not dark enough.
Please keep the solar panel clean by wiping it once every few months with a damp cloth or paper towel. Do not use strong detergents or acid-based cleaners.
Rainy and cloudy conditions over continuous days will also affect the charging ability of the light.
PLEASE NOTE THIS UNIT CHARGES IN THE ON POSITION. (–) LINE DEPRESSED INTO PANEL
IF LIGHT WILL NOT ILLUMINATE AFTER 2 SUNNY DAYS, UNPLUG LIGHT FROM SOLAR PANEL, LEAVE PANELSWITCH IN ON POSITION AND CONTINUE TO CHARGE LIGHT.
REATTACH LIGHT AND RESUME OPERATION AS NORMAL. IF LIGHT STILL WILL NOT WORK, REPLACE BATTERY.

The battery is 3.7V 2000mAh Li-ion rechargeable battery which is easily replaceable.
If the battery begins to illuminate dimly or for short durations of time and you know that it has had sufficient sunlight on the panel to charge, you should replace the battery in the following way:

Unscrew the battery cover on the back of solar panel box and take off the old battery carefully without damaging the cables.
Replace the new battery and remount the unit.

WARNING – Polarity is especially important. Switching polarity on the unit is dangerous and will destroy the unit.