eono S3 Active Noise Cancelling Headphone User Guide
- June 9, 2024
- eono
Table of Contents
eono S3 Active Noise Cancelling Headphone
Charging
- Fully dry off the USB port before charging.
- Use a certified USB-C charging cable and charger to prevent any damage.
Do not power on your headphone while charging
Powering On/Off
Press and hold the power button for 3 seconds to power on/off.
Bluetooth Pairing
- When powered off, press and hold the power button for 5 seconds until the LED flashes blue to enther the Bluetooth pairing mode.
- Select “Soundcore S3”on your device’s Bluetooth list to connect.
| Flashing blue | Bluetooth pairing | |
|---|---|---|
| Steady blue | Bluetooth connected |
Pairing with another device
When successfully connected with the first device,press twice the power button
to pair up with another devive.
- Your Soundcore headphone can only play music on one mobile device at a time.To play from another connected device,pause the device that’s currently active first
- Each time you power on your Soundcore headphone,it will automatically connect to your last successfully connected device if available within the Blutooth range.
Button Controls
Play/Pause
| |
Press
Next track
| | Press and hold for 1 second
Previous track| | Press and hold for 1 second
Volume up/down| | Press
Answer/End a call| |
Press
Put the current call on hold and answer a new incoming call
Reject a call
| |
Press and hold for 1 second
Switch between held call and active call
Activate Siri or other voice assistant software| | Press and hold for 1 second
Noise Cancellation Mode
To reduce ambient noise,turn on the active noise cancellation mode by pressing
the NC button.Press the NCbutton again to turn off.
Transparency Mode
To stay aware of your surroundings by allowing ambient sounds in,touch the
right panel for 1 second to activate the transparenc mode. AUX Mode
Play audio on an external device by plugging in a 3.5mm AUX cable. *When the
headphone is out of battery,you can still listen to music but ANC mode is
unavailable.
Reset
- You might need to reset your headphone if you experience any connectivity problems or function issues.
- Press and hold the power button and volume up button simultaneously for 5 seconds until the LED indcator flashes blue and red alternately twice.
Product parameters
Specifications are subject to change without notice
| Input | 5V 0.5A |
|---|---|
| Charging time | 1.5H |
| Play time ( with ANC mode turn on) | 10H |
| Play time ( with ANC mode turn off) | 15H |
| Driver size | 40 mm X 2 |
Impedance
| 20 Hz-20 kHz (Bluetooth)
16Hz-40kHz(AUX)
Bluetooth version| 16Q
Bluetooth Range| V5.0
Frequency Range| 15 m
CAUTION: Risk of explosion if the battery is replaced an incorrect disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion; leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.