Melitta LOOK Therm Selection Filter Coffee Maker Instruction Manual

: June 9, 2024
: Melitta

Table of Contents

Melitta LOOK Therm Selection Filter Coffee Maker
OVERVIEW
Safety notice
Before first use
Set water hardness
Making coffee
Using the insulated jug
Cleaning and maintenance
Note on disposal
Terms of guarantee
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Melitta LOOK Therm Selection Filter Coffee Maker

Melitta-LOOK-Therm-Selection-Filter-Coffee-Maker-
PRODUCT

Dear customer,
Thank you for buying our LOOK® Therm Selection ﬁlter coffee maker. We hope you will be very happy with it.
If you need further information or if you have any questions please contact Melitta® or visit us on the Internet at www.melitta.co.uk

For your safety

The appliance complies with all valid European guidelines.
The appliance complies with all valid United Kingdom guidelines.

The appliance has been tested and certiﬁed by an independent test institute.
Please read the safety notes and the operating manual in full. To avoid danger you must pay attention to the safety and operating instructions. Melitta® is not liable for damage caused by ignoring these instructions.

OVERVIEW

Melitta-LOOK-Therm-Selection-Filter-Coffee-Maker-FIG
1

A CALC button
B START button
C water level display
D handle to open the swing ﬁlter
E water tank lid
F AromaSelector®
G drip stop

Safety notice

This appliance is intended for use in households and similar areas, such as –

in kitchens for employees in shops, offices and other com- mercial areas
in agricultural companies
in motels, hotels and other residential facilities and bed and breakfast establishments

Any other use is considered to be improper use and may result in personal injury or damage to property. Melitta® is not liable for damage caused by improper use.

Please observe the following instructions to avoid injuries in case of misuse:

The appliance must not be placed in a cupboard during operation.
Connect the appliance only to a properly installed earthed socket.
The appliance must always be disconnected from the power

supply when unsupervised and before assembly, disassembly or cleaning.

During operation, parts of the appliance such as the steam outlet at the ﬁlter become very hot. Avoid touching these parts and avoid contact with hot steam.
Do not open the filter holder during brewing.
Do not use the appliance if the power cable is damaged.
Do not allow the power cable to come into contact with liquids.
Never immerse the appliance in water.
Do not clean the parts that come into contact with food with aggressive cleaning agents or scouring cream. Remove detergent residues with clean water. Further information on cleaning can be found under “Cleaning and care”.
This appliance can be used by children from 8 years of age or older if they are supervised or have been instructed in the safe use of the equipment and have understood the potential hazards. Cleaning and maintenance must not be carried out by children, unless they are 8 years or older and are supervised. Keep the appliance and the power cable away from children under 8 years of age.
The appliance may be used by persons with reduced physical, sensory or mental abilities or lack of experience and/or knowledge if they are supervised or have been instructed in the safe use of the appliance and have understood the potential hazards.
Children must not play with the appliance
Replacement of the power cable and all other repairs may only be carried out by Melitta® Customer Service or by an authorised repair shop.

Insulated jug

Do not use the jug in the microwave.
Do not place the jug on a hot stove.
Do not use the jug to store dairy products or baby food, as there is a risk of bacterial growth.
Do not lay the filled jug on its side, as liquid may escape.
Clean the outer casing with a soft, damp cloth.

ONLY for plastic jugs with glass insert

To prevent damage to the glass ﬂask, do not use hard or sharp-edged objects (e. g. cutlery, dishwashing brushes or similar) for stirring or cleaning and

do not ﬁll with ice cubes or carbonated liquids.

Do not subject the glass flask to high temperature ﬂuctuations.

Before first use

Ensure that the power supply in your home corresponds to that on the model plate on the base of the appliance.
Connect the appliance to a power source. Unused cable can be stored in the base of the appliance 1.
All appliances have been tested during production for perfect functioning. Therefore there may be for example water deposits remaining. Rinse the appliance twice with the maximum amount of water and without a ﬁlter bag or ground coffee, in order to clean it.
For the best coffee enjoyment and convenient use, the appliance is equipped with various features. These features are explained below.

Set water hardness

Depending on water hardness lime scale may build up in the appliance. This increases the appliance’s energy consumption as lime scale on the heating element can prevent the water heating effectively. To avoid damage the appliance must be descaled regularly. The descaling display helps you in this. If the CALC-button 2 is permanently lit this shows that the appliance needs to be descaled.
The appliance is pre-set for a high level of water hardness (level 4). You can ﬁnd out the level of water hardness in your area by asking your local water provider or by using water hardness measuring strips available in the shops. For softer water the descaling display can be adjusted to descale less often:

Hold down the CALC button b for longer than 2 seconds. The CALC button starts to ﬂash. In the factory settings the CALC button ﬂashes brieﬂy four times with the following pauses …………
You can set the water hardness at three further levels. Each time you brieﬂy press the CALC button b the display changes to ﬂashing one, two or three times, each time followed by a pause (…… ,…… ,……).
The settings and display are shown in the following table 1.
Once you have set the desired hardness level, again hold the CALC button b down for longer than two seconds. The light goes off and your settings are saved.

Please note:

Water hardness cannot be programmed while brew-ing.
The last water hardness level chosen remains even after removing the power cable.

Making coffee

Ensure that the appliance is connected to the power source.
Open the lid on the water tank 4.
Fill the water tank with the desired amount of water using the therm jug. With the help of the water level display on the tank 5 you can choose the correct number of cups. Small cup symbol = approx. 85ml coffee per cup, large cup symbol = approx. 125 ml coffee per cup.
Close the lid on the water tank and place the therm jug with closed lid in the appliance.
Open the swing ﬁlter 6 to the left.
Fold a Melitta® ﬁlter bag 1×4® at the embossed seam and place it in the ﬁlter holder 7. Press the ﬁlter bag into the ﬁlter holder by hand, to ensure a good ﬁt.
Put the ground coffee into the filter. The amount depends on your personal taste. We recommend using 6-8 g of ground coffee per large cup.
Swing the ﬁlter back into the appliance. An audible click tells you it is inserted properly.
With the Melitta® AromaSelector® 8 you can set the taste of your coffee with just one hand: From mild-aromatic ( ) to strong-intensive ( ).
Turn the appliance on c. Brewing begins.
The appliance switches off automatically at the latest 15 minutes after being switched on. This avoids unnecessary use of electricity and saves energy. You can of course turn the machine off manually at any time.
The drip stop prevents your coffee from dripping, when you remove the pot from the appliance 9.
With the help of the detachable inner filter you can dispose of the ﬁlter bag simply and easily.

Using the insulated jug

The brewed coffee flows through the central valve in the insulated lid of the jug.
To pour coffee press down on the sealing lever 11.
Remove the lid simply by pressing the seals on the side while lifting the lid up 12.

Cleaning and maintenance

External cleaning

The housing can be cleaned with a soft damp cloth.
The jug lid, the filter insert and the swing ﬁlter 10 can be washed in the dishwasher.

Descaling
The CALC button 2 lights up again if the appliance has been turned off without descaling. The CALC
button will go off again only after the descaling programme has been completely ﬁnished.
Based on the water hardness level you have set (see point 3) the descaling programme should be run promptly after the CALC button 2 lights up.

Follow the manufacturers instructions regarding amounts and pour the descaler into the water tank. We recommend using Melitta® “Anti Calc Liquid for Filter Coffee & Aqua Machines“.
Briefly press the CALC button b, it will start to ﬂash.
The descaling process will now run automatically. To remove even stubborn limescale the descaling process takes 25 minutes.
Attention: Only by carrying out the descaling process completely will all limescale deposits be removed and the light on the CALC button will go off. The descaling process should therefore not be interrupted before it has run for the full 25 minutes.
When the descaling process is completed the light on the CALC button will go off. The appliance will turn off automatically.
At the end of the descaling process, the appliance should be rinsed twice through, using the maximum amount of water without coffee. This will remove any remaining limescale deposits.

Note on disposal

Appliances labelled with this symbol are subject to European guidelines for WEEE (Waste Electrical and Electronic Equipment).
Electric appliances do not go in the household bin. Dispose of the appliance in an environmentally friendly way using suitable collection systems.
Packaging materials are raw materials and can be recycled. Please recycle them.

Terms of guarantee

In addition to the legal guarantee claims, to which the end user is entitled relative to the seller, for this device, if it was purchased from a dealer authorized by Melitta® due to his consulting competence, we grant a manufacturer´s guarantee under the following conditions:

The guarantee period begins with the day the product was sold to the end user. The guarantee is 24 months. The purchase date of the device must be verified by a purchase receipt.
The device was designed and built for household use only. It is not dedicated for a commercial use. Guarantee performances lead neither to an extension of the guarantee period nor to a new beginning of the guarantee period for the device or installed spare parts.
Within the guarantee period we will correct all device defects that are based on material or manufacturing errors, through repair or replacement of the device at our discretion. Replace parts become the property of Melitta®.
Defects that occurred due to improper connection, improper handling, or repair attempts by nonautho-rized persons are not covered by the guarantee. The same applies for failure to comply with the use, care, and maintenance instructions as well for the use of consumables (e.g. cleaning and decalcifying agents or waterfilters) that do not correspond to the original specifications. Wear parts (e.g. seals and valves) and fragile parts like glass are excluded from the guaran-tee.
Guarantee performances are processed via the Service Hotlines for the respective country (see information below).
These guarantee conditions apply for devices purcha-sed and used in UK If devices are purchased in foreign countries or brought into foreign countries, then guarantee performances will only be provided as spe-cified in the guarantee conditions applicable for this country.

Melitta UK Ltd.
Hortonwood 45
Telford, Shropshire, TF1 7FA United Kingdom
Tel: +44(0)800 0288002
www.melitta.co.uk