GARMIN External GNSS Antenna Instruction Manual

June 9, 2024
Garmin

GARMIN External GNSS Antenna

GARMIN External GNSS Antenna 

External Antenna Mounting Considerations

You can install the external antennas on your vehicle to get the most accurate position data for your navigation device. For best performance, consider these guidelines when selecting the antenna mounting location.

  • To ensure the best reception, you should mount the antennas in a location that has a clear, unobstructed view of the sky in all directions.
  • You should not mount the antennas near the engine or other sources of electromagnetic interference (EMI).
  • You must mount the antennas at least 5 cm (2 in.) apart from each other.

Installing the External GNSS Antenna

Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.

This antenna can be installed to provide a stronger GPS signal for your navigation device. This antenna uses a BNC connector to connect to the dock.

  1. Using the included mounting template, mark the three pilot-hole locations ① and trace the cable hole in the center of the template.
    Installing the External GNSS Antenna

  2. Drill the three 3.2 mm (1/8 in.) pilot holes.

  3. Use a 25 mm (1 in.) hole saw to cut the cable hole in the center.

  4. Place the surface-mount bracket ② on the mounting surface, aligning the screw holes.

  5. Use the included M4 screws ③ to secure the surface-mount bracket to the mounting surface.

  6. Place the large gasket ④ on top of the surface-mount bracket.

  7. Route the antenna cable through the 25 mm (1 in.) hole, and connect it to the antenna ⑤.

  8. Place the antenna on the surface-mount bracket, and twist it clockwise to lock it in place.

  9. Secure the antenna to the mounting bracket with the included M3 set screws ⑥.

  10. Route the cable into the vehicle and away from sources of electronic interference.

  11. Remove the 4 screws, washers, and nuts from the mount.

  12. Remove the ball plate ⑦ and Group Ride Radio (if necessary) from the mount.
    Installing the External GNSS Antenna

  13. Insert the External GNSS Antenna connector ⑧ through the corresponding hole in the mount ⑨ , and press the adapter to secure it to the mount.
    Installing the External GNSS Antenna

  14. Using the included screw, secure the adapter to the mount from the inside of the mount.
    Installing the External GNSS Antenna

  15. Replace the mount on the ball plate, and secure the mount using the 4 existing screws, washers, and nuts.

  16. Connect the External GNSS Antenna cable to the External GNSS Antenna connector on the mount.
    Installing the External GNSS Antenna

  17. Tighten the collar around the connected cables.

© 2022 Garmin Ltd. or its subsidiaries
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries.

© 2022 Garmin Ltd. or its subsidiaries

support.garmin.com

GARMIN Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals