EDEN GARDEN PRO Metal 4-Pattern Turbo Extension Watering Wand Instructions
- June 9, 2024
- EDEN GARDEN
Table of Contents
EDEN GARDEN PRO Metal 4-Pattern Turbo Extension Watering Wand
Instructions
Quick Assembly
- Completely loosen the main extension locking nut (counterclockwise).
- Extend the added extension. You can now see the wand head connection notch.
- Align the wand head connection notch with the added extension connection notch.
- Insert the added extension into the wand head all the way to the rubber o-ring.
- Tighten the added extension locking nut by turning it clockwise (Do not overtighten).
- Repeat the above steps for the wand handle.
REACHING CHALLENGING WATERING TASKS
Make watering hard-to-reach places easier with the 4-pattern Turbo Extension
Watering Wand. All done like a PRO. The 40- inch wand o°ers an extended reach
up to 66 inches to go further and clean hard-to-reach areas like under the car
or above the windows. The 270 degree pivoting head adjusts the spray angle to
get water exactly where you need it.
The Turbo Wand cleans all surfaces using a precise compact stream of water
that twists as it cleans. The circular twisting pulse motion quickly washes
dirt and debris away.
The PRO Metal 4-Pattern Turbo Extension Watering Wand helps you tackle your
most challenging cleaning chores. With four adjustable spray patterns, you can
go from watering hanging baskets and delicate plants to cleaning cars or
gutters. Easily adjust the water ˛ow with the smooth thumb control. No
squeezing of the handle is required.
- Turbo: Great for large surface cleaning such as gutters, driveways, windows, decks, and pavement or for deep water penetration of hard soil.
- Jet: Creates precise narrow strips and reaches a far distance. Useful for cleaning so°its, porches, balconies, lawnmowers, snowblowers, quadrunners, etc…
- Flat: Creates a wide spray of ˛at water. Useful to disperse and sweep leaves and dirt.
- Cone: Gives you a circle of spray so that you can water a ring of plants all at once.
Insulation
- Attach the adapter to the nozzle
- Quickly attach the connector at the end of your hose
- Snap the two together
- To unlock, push down the nozzle
CAUTION
- For outdoor use with cold water only
- Do not spray near electrical connections
- When not in use, rinse the tool with water to remove most of the dirt, dry your tool, and store it indoors
WARNING: This product can expose you to chemicals including styrene, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
The Quick Connect Adapter (2 pcs) and Hose Connector with Water Stop (1 pc) simplify your watering experience. Simply attach the connector at the end of your hose. Then, connect the adapters to your watering tools. Interchange various tools in a snap without turning off the water as the adapter will stop the water flow. No more kinking or hose twisting as the adapter allows the hose to swivel 360 degrees.