emerio FN-114474.1 Stand Fan Instruction Manual
- June 9, 2024
- emerio
Table of Contents
emerio FN-114474.1 Stand Fan
SAFETY INFORMATION
Before use make sure to read all of the below instructions in order to avoid
injury or damage, and to get the best results from the appliance.
Make sure to keep this manual in a safe place.
If you give or transfer this appliance to someone else make sure to also
include this manual.
In case of damage caused by user failing to follow the instructions in this
manual the warranty will be void.
The manufacturer/importer accepts no liability for damages caused by failure
to follow the manual, a negligent use or use not in accordance with the
requirements of this manual.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Before inserting the plug into the mains socket, please check that the voltage and frequency comply with the specifications on the rating label.
- Incorrect operation and improper handling can lead to faults on the device and injuries to the user.
- In the event of improper use or incorrect handling, no liability can be accepted for any damage that may occur.
- Do not immerse the unit or mains plug in water or other liquids. There is danger to life due to electric shock! However, if this occurs, remove the mains plug immediately and then have the unit checked by an expert before using it again.
- Do not operate the device if the mains cable or the mains plug show signs of damage, if the device has fallen on the floor or has been otherwise damaged. In such cases take the device to a specialist for checking and repair, if necessary.
- Never remove the mains plug from the socket by pulling on the mains cable, or with wet hands.
- Ensure that the mains cable does not hang over sharp edges or become trapped.
- Keep the appliance away from damp, and protect from splashes.
- Keep the appliance away from hot objects (e.g. hotplates) and open flames.
- Keep the appliance and its cord out of reach of children less than 8 years.
- Use the appliance on a flat, dry and heat resistant surface.
- Never leave the device unattended during use.
- Do not store or operate the appliance in the open air.
- Keep the appliance in a dry place, inaccessible to children (in its packaging).
- Never put fingers or any other objects through the fan guards when the fan is running.
- Never operate the product without the fan guards in place, as serious personal injury may result.
- The appliance must be assembled completely before use.
- Watch out for long hair! It can be caught in the fan owing to the air turbulence.
- Do not point the air flow to the people for a long time.
- After assembly, do not remove the guards during use or cleaning.
PARTS DESCRIPTION
- Clamping ring
- Front guard
- Blade fastening screw
- Fan blade
- Guard fastening screw
- Rear guard
- Motor shaft
- Shaft pin
- Oscillation button ( )
- Speed control buttons
- Upper standing shaft
- Lower standing shaft
- Standing base
- Screws and washers (4 pairs)
ASSEMBLING INSTRUCTIONS
Base and Standing Shaft Assembly
- Attach the lower standing shaft (12) onto the standing base (13). Use screws and washers (14) to fix the shaft firmly.
- Insert the upper standing shaft (11) into the lower standing shaft (12), turning the upper standing shaft (11) clockwise to tighten the connection of two shafts.
The Whole Assembly
- Remove the blade fastening screw (3) and guard fastening screw (5) from the motor shaft (7) spindle.
- Fit the rear guard (6) by positioning with the location pins. Secure the guard onto the motor body with the guard fastening screw (5).
- Place the fan blade (4) onto the motor shaft by matching the slot with the shaft pin (8). Fix the blade by tightening the blade fastening screw (3) in a counter-clockwise direction. Check that the fan blade can rotate freely by turning it with your hand.
- Put the front guard (2) against the rear guard (6) and fix with the clamping ring (1). Make sure the clamping ring is set properly at the rim of the fan guards. Tighten the screw on the clamping ring.
OPERATING INSTRUCTIONS
- Plug the power cord into a suitable socket.
- Oscillation: To make the fan head oscillate, press the oscillation button (9). To stop the fan head from oscillating, press the button “0”, and then restart the fan.
- The fan is switched on and off by pressing the speed control buttons, i.e. 0 = Off, 1 = Low air flow speed, 2 = Medium air flow speed, 3 = High air flow speed.
- Tilting Angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
CAUTION: Press only one of the speed control buttons at a time. Permanent damage to the switch housing may result if two or more of the buttons are pressed simultaneously.
CLEANING
- Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable from the socket.
- Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down with a damp cloth and dry it carefully. Always take out the mains plug first.
- Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
- Operating voltage: 220-240V ~ 50-60Hz
- Power consumption: 55W
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control.
If, despite all care, damage has occurred during production or transportation,
please return the device to your dealer.
In addition to statutory legal rights, the purchaser has an option to claim
under the terms of the following guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day
of sale.
If you have a defective product, you can directly go back to the point of
purchase.
Defects which arise due to improper handling of the device and malfunctions
due to interventions and repairs by third parties or the fitting of non-
original parts are not covered by this guarantee.
Always keep your receipt, without the receipt you can’t claim any form of
warranty.
Damage caused by not following the instruction manual, will lead to a void of
warranty, if this results in consequential damages then we will not be liable.
Neither can we hold responsible for material damage or personal injury caused
by improper use if the instruction manual is not properly executed.
Damage to accessories does not mean free replacement of the whole appliance.
In such case please contact our service department. Broken glass or breakage
of plastic parts is always subject to a charge.
Defects to consumables or parts subjected to wearing, as well as cleaning,
maintenance or the replacement of said parts are not covered by the warranty
and are to be paid.
ENVIRONMENT FRIENDLY DISPOSAL
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other
household wastes.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources.
To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Emerio B.V. Oudeweg 115 2031 CC Haarlem The Netherlands
Customer service:
T: +31 (0) 23 3034369
www.emerio.eu/service
Kundeninformation:
T: +49 (0) 3222 1097 600
www.emerio.eu/service
Klantenservice:
T: +31 (0) 23 3034369
www.emerio.eu/service
Looking for spare parts? Have a look at
www.spareparts.emerio.eu
Sie brauchen Ersatzteile? Besuchen Sie
www.ersatzteile.emerio.eu
Onderdelen nodig? Kijk op
www.onderdelen.emerio.eu
ERP information (EN)
- Supplier:
- Emerio B.V.
- Oudeweg 115
- 2031 CC Haarlem
- The Netherlands
Declare that the product detailed below:
Information requirements
Information to identify the FN-114474.1 to which the information relates to [Stand Fan]
Description| Symbol| Value| Unit
Maximum fan flow rate| F| 48,1| m3/min
Fan power input| P| 53,2| W
Service value| SV| 0,9| (m3/min)/W
Standby power consumption| PSB| —| W
Fan sound power level| LWA| 50,3| dB(A)
Maximum air velocity| c| 3,0| meters/sec
Measurement standard for service value| IEC 60879:2019 – Comfort fans and
regulators for household and similar purposes – Methods for measuring
performance
Contact details for obtaining more information| Emerio B.V. Oudeweg 115
2031 CC Haarlem The Netherlands
Satisfies the requirement of the Council Directives:
COMMISSION REGULATION (EU) No 206/2012 of 6 March 2012 and Amending COMMISSION
REGULATION (EU) 2016/2282 implementing Directive 2009/125/EC of the European
Parliament and of the Council with regard to eco-design requirements for air
conditioners and comfort fans Regarding information for consumers on how to
install, use and maintain the product, WEEE information, please check the
instruction manual provided with packaging
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>