DOMINATOR 160443TBA Smart and Secure Sectional Door Open User Manual
- June 9, 2024
- DOMINATOR
Table of Contents
DOMINATOR 160443TBA Smart and Secure Sectional Door Open
Operating Controls
Button | Function |
---|---|
01 | Close |
02 | Close indicator |
03 | Stop |
04 | Open |
05 | Open indicator |
06 | Mode |
07 | Status indicator |
08 | Battery status indicator |
09 | Remote status indicator |
10 | Adjustment indicator |
11 | Network indicator |
Manual Door Operation
To Disengage the Opener:
- It is recommended to do so with the door in the closed position.
- Pull the manual release cord towards the door, until youhear a click.
- Move the door manually.
CAUTION: When the opener is manually disengaged, the door is no longer locked. To lock the door manually, re-engage the opener after the door is closed.
To Re-Engage the Opener:
- Check the door has not been locked by a locking device.
- Pull the manual release cord away from the door, until you hear a click.
- The door will now operate from the opener.
CAUTION: Do not use the string handle as a mechanism to open the door. Failure to comply may cause serious injury.
Coding a Remote Control
Storing the Remote Control Code:
The opener can only be operated from remote con-trollers that have been
programmed into its memory. Up to 64 remotes can be stored in the memory.
- Remove the controls cover to access the buttons.
- Press the MODE button repetitively until the REMOTE INDICATOR is lit.
- Press and HOLD the CLOSE button to set Open /Stop / Close function. The Main light will start to flash rapidly.
- Press one of the four (4) buttons on the transmitter until the main light starts to Main Light Remote Status flash rapidly, then release transmitter ON Button added button.
- Press the remote control button again until the main light stops
- Release both buttons. Press the MODE button to exit. and refit controls cover. The remote button is now coded, press to test
Main Light | Remote Status |
---|---|
ON | Button added |
OFF | Button removed |
2 flashes, then OFF | Remote control deleted |
4 flashes, then OFF | Memory full |
Battery Replacement:
Battery Type: 1 x CR2032.
- To test the battery is working, press and hold a remote button. Check Light Status table to determine if battery needs replacing.
- Use finger nails to separate the remote casing to expose circuit board.
- Use a non-metallic object to push the battery down through the side opening to remove the battery
Light Status | Battery Status |
---|---|
Solid | OK |
Flashing | Replace |
No light | Replace |
WARNING! The battery is hazardous and must be kept out of reach of children.The battery can cause severe or fatal injuries within 2 hours or less if swallowed or placed inside any part of the body.If you suspect the battery has been swallowed or placed inside any part of the body, SEEK IMMEDIATE medical attention.
Smart Phone Control (Smart DSO-3 Only)
Connecting to WiFi:
The Smart Phone Control works via your home’s WiFi network. Initial set up
involves linking your phone app and smart opener to your home network.
- Download the Dominator App.
- Remove the controls cover on opener to access the buttons.
- Ensure the WiFi router is within range of the opener.
- On the opener press the MODE button repetitively until the NETWORK Indicator is lit.
- Press and hold the OPEN button on the opener for 4 seconds. The NETWORK Indicator will turn purple when Hot Spot is Active.
- Go to phone settings, then WiFi and select (DOM000000).
- Open App and tap on Start.
- Select setup a new Smart Opener.
- Follow on screen instruction in the Dominator App.
- Upon completion, refit the controls cover and test the opener operation through the Dominator App.
Troubleshooting
Main Light = Service / Warning Indicator:
Requirements for a service and user warnings are indicated after operation by
the main light repeatsble flashing OFF a number of times followed by a pause.
The below table identifies the issues and remedies.
Caring for your Opener
Preventative servicing of your garage door and opener, is important. Your garage door is made up of numerous moving parts designed to lift and lower your door safely and efficiently. Ongoing preventative servicing ensures that your door continues to function within factory specifications, greatly reduces the risk of failure and repair bills down the track and ensures you maintain your Warranty. Refer to your Owners Opener Handbook for your service schedule.
Need a Service Call?
If the opener needs a service please call the dealer who installed the garage
door opener (their contact details are usually on a sticker on the back of
your garage door).
For product assistance, general enquiry or more information, please visit: dominator.co.nz or call 0800 366 462.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>