PHILIPS SCD303-01 Avent Newborn Natural Starter Set User Manual
- June 9, 2024
- Philips
Table of Contents
PHILIPS SCD303-01 Avent Newborn Natural Starter Set
Read all instructions carefully before use. Keep the user manual and product packaging for future reference. For your child’s safety and health
WARNING
- Continuous and prolonged sucking of fluids will cause tooth decay.
- Always check food temperature before feeding.
- Throw away at the first signs of damage or weakness.
- Keep components not in use out of the reach of children.
- Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
- Never use feeding teats as a soother.
- Glass bottles may break.
- Always use this product with adult supervision.
It is not recommended to use a microwave to warm up baby food or drinks. Microwaves may destroy valuable nutrients in food/drinks and may produce localized high temperatures. If you decide to use the microwave, take extra care to stir heated food/drinks to ensure even heat distribution and check the temperature before serving. Only place the container in the microwave, without the screw ring, teat and cap. Do not allow children to play with small parts or walk/run while using bottles. Always discard any breast milk that is left over at the end of a feed. Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness. Do not use metal inside the glass bottle to stir contents or for cleaning. This can damage the glass. Do not use bottles if there are any cracks on or glass fragments in the bottle. Do not use bottle handles with glass bottles. Prolonged wear or development of scratches may lead to breakage.
Before first use
Disassemble all parts, clean and then sterilize the parts by placing in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that the feeding teat is fully pulled through the screw ring as
shown in the image (Fig. 1, 2).
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each use, disassemble
all parts, wash in warm, soapy water, remove any food residues and rinse
thoroughly. Then sterilize using a Philips Avent sterilizer or boil for 5
minutes. Make sure that you wash your hands thoroughly and that the surfaces
are clean before contact with sterilized components. During sterilization with
boiling water, prevent the parts from touching the side of the pot. This can
cause irreversible product deformation, defect or damage that Philips cannot
be held liable for. Food colorings may discolor parts. This product is
dishwasher safe. Do not place the product in a heated oven. Do not bring the
bottle parts in contact with or place on surfaces with abrasive or
antibacterial cleaning agents. We recommend replacing
feeding teats every 3 months. Keep feeding teats in a dry, covered container.
Do not leave a feeding teat in direct sunlight or heat, or leave in
disinfectant (sterilizing solution) for longer than recommended, as this may
weaken the teat.
Compatibility
Replacement teats are available separately. To learn more about choosing the right teat for your baby, visit us at www.philips.com/avent. These bottle parts are compatible only with Philips Avent Natural teats.
Support
If you need information or support, please visit www.philips.com/support.
www.philips.com/avent Philips Consumer Lifestyle B.V. Tussendiepen 4, 9206 AD Drachten, The Netherlands Trademarks are the property of Koninklijke Philips N.V. © 2021 Koninklijke Philips N.V. All rights reserved
References
- Baby Care Products, Accessories & Baby Essentials | Share the Care
- Philips Customer Service Support - Home | Philips
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>