PENTAIR BE882 Berkeley B-Series SAE Mount Centrifugal Pumps Instruction Manual
- June 9, 2024
- Pentair
Table of Contents
InstallatIon InstructIons
B_ZQ_S SAE 1.510T Spline;
B_ZR_S Frame Mount
Shaft Replacement Kit
GENERAL
unpack shaft replacement kit and compare contents with the parts list below.
Verify kit received is the correct one for your operation.
California Proposition 65 Warning
WARNING this product and related accessories contain chemicals known to
the state of california to cause cancer, birth defects or other reproductive
harm.
PARTS LIST
Ref. No.| Part Description| Qty.| B-ZQ-S
B85738| B-ZR-S
B-8-57Y9
---|---|---|---|---
1| Capscrew| 1| S23621| S23621
2| Lockwasher| 1| S23038| S23038
3| Impeller Washer| 1| S06319| S06319
4| Slinger| 1| S10964| S10964
5| Grease Seal| 2| M12337| M12337
6| Shaft Sleeve| 1| M15098L| M15098L
7| Ball Bearing| 1| M15097| M15097
8| Shaft Key| 1| S23677| S23677
9A| Shaft| 1| M15092| –
9B| Shaft| 1| –| M15091
10| Shaft Key| 1| –| S23941
11| Ball Bearing| 1| M15096| M15096
12| Thrust Ring| 1| M15095| M15095
13| Retaining Ring| 1| M15094| M15094
INSTALLATION
-
thoroughly steam clean or solvent wash the bearing cavity of bearing bracket to remove old grease and dirt. check surface of bracket for cracks, extreme corrosion, or other defects that may make replacement of the bracket necessary.
-
Pack bearings with a lithium based nGlI no. 2 extra pressure ball bearing grease.
Force enough grease into each bearing to fill internal space between the races. -
coat the bearing bores of bracket with oil. orient shaft kit in the direction shown above.
Protect the bearings from contamination during installation by applying grease around bearings as shown. slide shaft and bearing assembly into bearing bracket. When threaded end of pump shaft comes through inner grease seal, place slinger over end of shaft. If packing gland is not of the split variety, place it over the shaft at this time as well. slide shaft on through stuffing box until the first bearing makes contact with the bracket. BE surE that you do not damage the inner grease seal. carefully align bearing with the bearing bore and press or slide bearing assembly into place. Do not use excessive force. -
Install outer bearing cap tightly against bracket.
-
Inject grease into grease fittings to fill cavities behind bearings.
-
reassemble pump parts and install unit. refer to pump owners manual for correct installation procedures.
293 WRIGHT STREET, DELAVAN, WI 53115
WWW.BERKELEYPUMPS.COM
PH: 888-237-5353
© 2013 Pentair, Ltd. All Rights Reserved.
BE882 (Rev. 02/25/13)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>