LUMENTruss 180 Flex Neon Sleeves Luminaire Installation Guide

June 9, 2024
LUMENTRUSS

180 Flex
SÉRIE NEON SLEEVE SERIES
INSTALLATION SHEET

180 Flex Neon Sleeves Luminaire

Install the mounting brackets (a) on the desired surface using provided screws (b).| Install the Neon Sleeve (c) into brackets.
Make electrical connections (pp.3-4).
---|---
|

ENDCAPS AND WIRING OPTIONS

WIREWAY EXAMPLE

INSTALLATION OPTIONS

Curved installation – min. inner bend radius 125mm (5”).| Straight installation.
---|---
|

WARNING

Minimum inner bend radius 125mm (5in).| Minimum inner coil diameter is 350mm (14in).
---|---
|

Up/down bend. The Neon Sleeve can only be bent in the direction perpendicular to the LED strip (see diagram below).

UP/DOWN BEND

COMPONENT PARTS

a – PVC brackets
b – Mounting screws
c – 180F Neon Sleeve
d0, d1 – Endcaps
e – LED tape

ELECTRICAL CONNECTIONS

See the the next page for different connection options depending on LED tape and dimmer types.

WARNING: RISK OF ELECTRIC SHOCK
To prevent electric shock, power should be turned off from the electrical panel before installation or maintenance process.
INSTALLATION MUST COMPLY WITH ALL CURRENT NATIONAL AND LOCAL ELECTRICAL CODES.

LOW VOLTAGE CONNECTION

1.A HARDWIRE CONNECTION

  • Join the black wire from the LED tape (1) (-) with the black output wire from the low voltage power supply (2).
  • Join the white or red LED tape wire (+) to the white or red power supply output wire.
  • Use appropriate twist-on (or equivalent) connectors to isolate wires.

1.B PLUG-IN CONNECTION WITH DC PLUG
Connect input connector of the LED tape (1) to the output connector of the low voltage power supply (2).

LINE VOLTAGE CONNECTION

  • Pass the main power feed (not included) and power supply input cable (3) into junction box (not included).
  • Connect the white (N, Neutral) cables from the power feed and from the power supply.
  • Connect the black (L, Live) cables from the power feed and from the power supply.
  • Connect the copper, green or yellow (G, ground) wires from the power supply, power feed, and the junction box. Use appropriate twist-on connectors (not included).
  • Install the junction box cover (not included).

WIRING DIAGRAMS

LOW VOLTAGE CONNECTION (LED TO POWER SUPPLY)

LINE VOLTAGE CONNECTION (POWER SUPPLY TO AC MAINS)

WARNING:
Use only Class 2 rated components.

www.lumentruss.com / 1 855 384 3384 / 1 514 903 5863 / 9221, Rue Edison, Montréal (Québec), H1J 1T4
LumenTruss reserves the rights to make changes to this document at any time without prior notice.
JAN2022-01

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals