LUMENTRUSS LM99997-01 Mini Side Flex Installation Guide
- June 9, 2024
- LUMENTRUSS
Table of Contents
LM99997-01 Mini Side Flex
Installation Guide
LM99997-01 Mini Side Flex
INSTALLATION SHEET
Install the mounting brackets (a) on the desired surface using provided
screws (b).
Install the Neon Sleeve (c) into brackets.
Make electrical connections (pp.3-4).
END CAPS AND WIRING OPTIONS
WIRE WAY EXAMPLE
INSTALLATION OPTIONS
Curved installation – min. inner bend radius 90 mm (3.5”).
Straight installation.
WARNING
Minimum inner bend radius 90 mm (3.54 in).
Minimum inner coil diameter is 250 mm (9.84 in).
Side bend. The Neon Sleeve can only be bent in the direction
perpendicular to the LED strip (see diagram below).
SIDE BEND
FRAGILE ELECTRONIC COMPONENTS
HANDLE WITH GREAT CARE
COMPONENT PARTS
a – PVC brackets
b – Mounting screws
c – MSF Neon Sleeve d0, d1, d2 – End caps
e – LED tape
ELECTRICAL CONNECTIONS
See the the next page for different connection options depending on LED tape and dimmer types.
WARNING: RISK OF ELECTRIC SHOCK
To prevent electric shock, power should be turned off from the electrical panel
before installation or maintenance process.
INSTALLATION MUST COMPLY WITH ALL CURRENT NATIONAL AND LOCAL ELECTRICAL CODES.
-
LOW VOLTAGE CONNECTION
1.A HARDWIRED CONNECTION
• Join the black wire from the LED tape (1) (-) with the black output wire from the low voltage power supply (2).
• Join the white or red LED tape wire (+) to the white or red power supply output wire.
• Use appropriate twist-on (or equivalent) connectors to isolate wires. 1.B PLUG-IN CONNECTION WITH DC PLUG
Connect input connector of the LED tape (1) to the output connector of the low voltage power supply (2). -
LINE VOLTAGE CONNECTION
• Pass the main power feed (not included) and power supply input cable (3) into junction box (not included).
• Connect the white (N, Neutral) cables from the power feed and from the power supply.
• Connect the black (L, Live) cables from the power feed and from the power supply.
• Connect the copper, green or yellow (G, ground) wires from the power supply, power feed, and the junction box. Use appropriate twist-on connectors (not included).
• Install the junction box cover (not included).
WIRING DIAGRAMS
LOW VOLTAGE CONNECTION (LED TO POWER SUPPLY)
Non-dim. / ELV / TRIAC
DMX
SINGLE COLOR (2 PINS)
LINE VOLTAGE CONNECTION (POWER SUPPLY TO AC MAINS)
Non-dim. / 0-10V / DMX / RGB contr. / GRE Alpha
TRIAC
ELV
WARNING:
Use only Class 2 rated components.
www.lumentruss.com
1 855 384 3384/1 514 903 5863
9221,Rue Edison, Montréal (Québec), H1J 1T4
Lumen Truss reserves the rights to make changes to this document at any time
without prior notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>