BURG WACHTER RS 110 C SB Lock User Manual
- June 4, 2024
- BURG WACHTER
Table of Contents
RS 110 C SB
Assembly and user manuals
Structure
Operation
Open
To open, rotate all 4 dials to the pre-set combination along the center line. The pre-set factory combination is 0-0-0-0. The dials stop automatically at 0 if they are turned towards the side bolt. This functionality is helpful when the lock is opened in poor light, as the clicks of the turning dials can be counted.
Set your own combination
On the end of the locking bolt, fully depress the small silver pin. (Fig. 1)
Whilst holding in the pin, rotate the 4 dials to your chosen secret
combination. Ensure the numbers are positioned centrally and have clicked into
position. Release the pin to the original position. Memorize and record the
new combination for future reference.
The new code is now set.
Note: If the new code is lost, the lock cannot be opened anymore.
Lock
The combination must be scrambled by rotating the 4 dials. The slide bolt can
be latched both while open and closed.
Fitting instructions
Note: Regular screws can be used to temporally fix the locking bolt before finally fixing using the security screws supplied. It is important to drill a small pilot hole for the screws as they cannot be unscrewed once used.
-
Hold the slide bolt in the required position and check the slide bolt and the gate/door will function correctly. Once positioned correctly, mark the location of the 4 screw holes.
-
The slide bolt should be mounted using all 4 corner fixing holes on the back plate. Drill a small pilot hole for the screws. Screws should be tight without distorting the back plate.
Depending on the material of the installation place it may make sense to drill small GUI- ding holes to facilitate fitting. Drills should be chosen according to material and screw diameter. It may be advantageous to use dowels. -
Hold the centerpiece in the required position and check the slide bolt and the gate/door will open and close correctly. Mark the location of the 2 screw holes and drill small pilot holes. Fix in position using the screws.
Maintenance: It is recommended the dials are rotated weekly to keep them moving freely. Please clean the lock with a wet cloth if required, and use a common lubricant for the locking mechanism.
Mistakes and changes are reserved.
Weitere Sprachen auf:
www.burg.biz
Further languages at:
www.burg.biz
BURG-WÄCHTER KG
Altenhofer Weg 15
58300 Wetter
Germany
www.burg.biz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>