Shark NV200 Series DuoClean Slim FAQs

: June 9, 2024
: Shark

Table of Contents

Shark NV200 Series DuoClean Slim FAQs
FAQs
General questions:
General questions about using the vacuum:
General questions about maintenance:
Product Specifications:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Shark NV200 Series DuoClean Slim FAQs

Shark NV200 Series DuoClean Slim

This article contains the FAQs for the NV200 Series Shark® DuoClean® Slim. This supports the following product SKUs NV200, NV200C, NV200Q, NV201, NV202, NV202C, QU201QBL, QU202QBL, QU202QPL, QU202QRD, QU202QS, QU203QBL, QU203QPL, QU203QRD, and QU203QS.

FAQs

General questions:

Why is the Shark DuoClean Slim Upright vacuum better than traditional vacuums?

Shark’s only Slim upright with DuoClean Technology is ultra-powerful and lightweight. It’s DuoClean Technology dual brushroll system has two brushrolls working in unison to remove the three types of dirt from your floors and carpets: large, small and stuck-on particles. Its Anti-Allergen Complete Seal Technology system traps over 99.99% of dust and allergens inside the vacuum*, keeping them out of the air you breathe.

*Based on ASTM F1977 of particles 0.3 microns and larger.

What is Anti-Allergen Complete Seal Technology?

If your vacuum is an unsealed HEPA vacuum, dirt and allergens that you vacuum up can escape back into the air that you breathe before they even reach the HEPA filter. With Anti-Allergen Complete Seal Technology incorporated with the HEPA filter, the vacuum captures and holds over 99.9% of dust and allergens inside the vacuum*, so that it is not released back into the air you breathe.

*Based on ASTM F1977 of particles 0.3 microns and larger.

Can I turn the headlights off?

The powerful LED headlights are designed to illuminate debris in dark spaces to make cleaning more efficient. The headlights will illuminate whenever the power is on and are designed to last the life of the vacuum.

General questions about using the vacuum:

How do I begin cleaning floors?

The Shark DuoClean Slim Upright vacuum has two powerful settings for cleaning: Carpet Mode and Hard Floor Mode. Note that the headlights will illuminate anytime the power is on.

Hard Floors:

Press the power button on top of the canister to turn on suction. Make sure the green light on the other side of the canister labeled “Carpet/Hard Floor” is NOT illuminated. Tilt the handle back while you gently step on the floor nozzle. The brushrolls will begin spinning. Note that the brushrolls will spin slowly in this mode.

Carpets:

Press the power button on top of the canister to turn on suction. Make sure the green light on the other side of the canister labeled “Carpet/Hard Floor” is illuminated. If it’s not, press the Mode Selector button to illuminate it. Tilt the handle back while you gently step on the floor nozzle. The brushrolls will begin spinning. Note that the brushrolls will spin faster in this mode.

Hose and accessories for above floor mode:

Press the handle or wand release button on the back of the handle, depending on the amount of reach you require. Lift the handle up, insert an accessory onto the end of the wand, press the power button, and begin cleaning.

How do I remove the handle to clean above floors?

Press the handle release button on the backside of the handle with one hand. Gently pull up with the other hand to remove the handle from the wand. Add the desired accessory and begin cleaning.

How do I remove the handle with extension wand to clean above floors?

Press the wand release on the backside of the handle with one hand and gently pull up on the top handle to the remove wand. Add the desired accessory to the end of the wand and begin cleaning. To replace, simply guide the wand behind the canister and press down until you hear an audible click.

How do I detach the Pod for portable cleaning?

The Shark DuoClean Slim Upright vacuum also can lift away for portable cleaning and the ultimate lightweight experience. Simply detach the handle or wand and attach the desired accessory to the end. Remove the floor nozzle by pressing the nozzle release button on the side of the vacuum. Pull the canister up by the handle while gently stepping on the floor nozzle. You are now ready to clean hard-to-reach areas, like stairs or your car. To keep the cord out of your way while vacuuming, attach it to the cord hook just below the handle.

How do I turn the vacuum off?

To turn the vacuum off, simply press the power button.

General questions about maintenance:

How do I clean the filters and how often?

Make sure the unit is unplugged.

Pre- Motor Filters:

Remove the dust cup and pull the flat foam filter out from the motor housing. Then remove the felt filter using the small ribbon pull-tab. Rinse filters thoroughly in lukewarm water until the water runs clear. Squeeze out excess water and let air-dry completely for at least 24 hours before replacing. Do not place filters in the dishwasher or washing machine. To replace inside the vacuum once dry, put the felt filter in first, then add the foam filter.

Hepa Filter:

Remove the filter cover from the front of the vacuum by pulling the latch from under the motor housing. Remove the HEPA filter cartridge, pull off the pre- HEPA filter and rinse them both under lukewarm water, dirty side down, until the water runs clear. Allow the filters to air-dry completely for 24 hours. Once the filters are dry, snap them back together and place them back into the vacuum, then replace the cover by lining up the tabs on one side and swinging the door securely closed until it clicks into place.

How do I empty the dust cup and how often?

To empty the dust cup, first remove it from the vacuum. Press the dust cup release button on the top of the canister and lift off the dust cup. Next, hold the dust cup over the trash and press the bottom door release button on the front of the unit. Tap gently to empty contents. Press the door shut until it clicks. If needed, press the top door release button and remove the fluff screen to clean. Tap gently to remove contents or wipe clean with a soft cloth. Remember to replace the fluff screen after emptying.

For optimal performance, empty the dust cup when dirt reaches the “max fill” line.

How do I maintain the brushroll?

Brushroll:

Open the three locks on the bottom of the floor nozzle. To open each lock, insert the edge of a coin into the slot and turn counterclockwise.

Lift tabs and pull up to expose the airway, then tilt the nozzle neck back to straighten. Use a flashlight to check for blockages in the airway

Remove any string, carpet fibers, or hair that may be wrapped around the brushroll. To loosen debris, run scissors along the groove in the brushroll.

To close the nozzle, push down until it clicks into place, then fasten the locks with a coin.

Softroller:

Slide the Soft Roller access button up to remove the Soft Roller.

To clean Soft Roller, first tap lightly to loosen debris, then wipe with a dry towel to remove any fibers or hair in the teeth behind the Soft Roller.

Wash the Soft Roller as needed. Use only water, and let air-dry completely for at least 24 hours.

Reinsert the Soft Roller by sliding it into the front of the nozzle until it clicks into place.