MAYTAG W11586438 Compressor Service Kit Instructions

MAYTAG W11586438 Compressor Service Kit

Kit Includes

Instruction Sheet Start Relay Compressor Mounting Bolts (4) Washers (4)
Wiring Diagram (2) Overload Relay Protector Cover Grommets (4) Nuts (4)
Schematic Diagram (2) Spring Clip Clamp Sleeves (4)

Instruction Sheet

Compressor Service Kit

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

IMPORTANT: The new compressor does not use a capacitor.

1. Disconnect power to wine center.
2. Evacuate the sealed system as per Whirlpool Technical Manual W10393765.
3. Disconnect the suction and discharge lines from the compressor.
4. Remove and discard the protector cover.
5. Remove and discard the capacitor, mounting nuts, and washers.
6. Remove and keep the ground screw and washer connecting the green/yellow ground wire to the compressor.
7. Disconnect the red (L) and black (N) wires from the overload and start relays on the  compressor.
8.  Remove and discard the original compressor mounting bolts, washers, and nuts.
9. Remove and discard the original overload and start relays.
10. Remove and dispose of the original compressor as per your company’s standard process.
11. Install the new grommets and sleeves into the new compressor.
12. Slide the spring clip from the kit around the new overload protector, then insert the ends of the clip into the slots on the left side of the new compressor fence (see image).
13. Connect the wire coming from the protector to the top round terminal on the compressor
14. Plug new starter into the bottom two round terminals on compressor.
15. With the relay and protector attached, mount the new compressor to the chassis using the mounting bolts, nuts, and washers from the kit.
16. Connect the red (L) wire from the unit harness to the spade terminal on the overload protector.
17. Connect the black (N) wire from the unit harness to the spade on the starter relay
18. Using the screw and washer removed in step 4, connect the yellow/green ground wire from the unit to the hole on the right side of the compressor fence (see image).
19. Install new cover onto compressor fence using the clamp (see image).
20. Connect the suction and discharge lines to the new compressor, and follow the Whirlpool Technical Manual W10393765 to properly complete the sealed system repair.
21. Replace the wiring diagram & schematic on the unit with a new wiring diagram & schematic from the kit that matches the model number of the unit.
    

Whirlpool Corporation 2022
(All Rights Reserved)
W11586438 Rev. A

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>