MODERN FORMS PD-78013 4 Watt Minx LED Pendant Instruction Manual
- June 9, 2024
- MODERN FORMS
Table of Contents
INSTALLATION INSTRUCTIONS
780-LED Pendant
PD-78013
Instruction Manual
PD-78013 4 Watt Minx LED Pendant
CAUTION: TO PREVENT ELECTRICAL SHOCK, ENSURE ELECTRICITY HAS BEEN TURNED
OFF AT THE CIRCUIT BREAKER BEFORE BEGINNING.
– Read all instructions before installing.
– System is intended for installation by a licensed electrician in accordance
with the National Electrical Code (NEC) and local regulations.
– When handling the fixture, do not apply pressure to the LEDs. Hold the
fixture by the base only.
– Retain installation instructions for future maintenance reference.
WARNING: All parts must be used as indicated in these instructions. This
product is designed for use only with the supplied parts and/or accessories
designated for use by Modern Forms. Substitution of parts or accessories not
designated for use with this product by Modern Forms could result in personal
injury or property damage, and will void the warranty. Contact an authorized
dealer or the manufacturer if any parts are damaged or missing.
MAINTENANCE NOTE: Coastal conditions may cause mineral and residue build-
up on the fixture. We recommend that customers in coastal areas clean all
external surfaces of the fixture once every two weeks with a wet cloth.
HARDWARE
PREPARATION
-
Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1) -
Remove the mounting screw (B) and back plate from the fixture.
-
Adjust the fixture wire length by pushing the cable gripper on the canopy and pulling the wire as desired.
a) Retract these wires close to a desirable length to within the canopy before securing the fixture in place.
Note: retracting or extending excessive cable length through the cable gripper is not commended.
b) Warning: Shortening these cables without professional helps or electronic background is not advisable.Any modifications to the fixture may result in voiding the warranty of the product. -
Secure the mounting back plate to the junction box using standard junction box screws that comes with the junction box.
Note: (i) using any other non-original-manufacturer provided junction box screws may result in safety issue; (ii) the side of the mounting plate marked “GND”must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the driver’s input wires to junction box wires as shown in Fig. 2, make sure that all wire connectors (A) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
Caution: This fixture requires driver’s to be recessed within the junction box. The hole mounting extensions on the driver are trimmable/foldable for tighter junction box
fitment.
COMPLETING THE INSTALLATION -
Secure the fixture to the mounting back plate using the mounting screw (B).
DIMMING WIRING INFORMATION (Fig. 3) -
To utilize ELV or TRAIC dimming: use wires black (hot), white (neutral) and bare copper ground wire (ground).
Fig. 2 Wiring
Fig.1
Modernforms.com
Phone (866) 810.6615
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
Modern Forms retains the right to modify the design of our products at any
time as part of the company’s continuous improvement program.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>