PHILIPS BGC010 Essential SmartBright Solar Spot
- June 9, 2024
- Philips
Table of Contents
BGC010
Essential SmartBright Solar **Spot
Instruction Manual**
Mounting instruction
Type Number| Flux(Im)| Battery type| Battery parameter|
PV voltage| CCT| Ta
---|---|---|---|---|---|---
BGC010 LED3/730 Spot| 3001m| Ternary lithium| 3.7V/2.0Ah| 5.8V/1.75W| 3000K|
0-45°C
BGC010 LED1/730 Spot| 1001m| Ternary lithium| 3.7V/1.2Ah| 5.8V/1.75W| 3000K|
0-45°C
| TYPE | H | d1 | d2 |
|---|---|---|---|
| Lamp body | 313 | 95 | 141 |
| PV panel | 275 | 84 |
Unit: mm
Installation:
Type A：
| 
---|---
Fix the grounding part on the lamp body| Insert into the ground and adjust the
PV and lamp
Type B：
|
---|---
Punch 3 pre-installed holes of Φ7.8
| Insert the plastic expansion tube
|
Mount the lamp & fix the screws| Adjust the PV and lamp angle
Button Function:
On| Press and Hold button >2S| Wake up with last working mode, charging during
daytime, light up after dusk automatically.
After wake up, it will light up for 1s and then turn off if at daytime, it
will light up if at night
---|---|---
3H| Press button & flash 1 times| Light on with bright mode after dusk till
battery low, indicatively in 3 hours on a full battery
6H| Press button & flash 2 times| Light on with half-light mode after dusk
till battery low, indicatively in 6 hours on a full battery
12H| Press button & flash 3 times| Light on with low-light mode after dusk
till battery low, indicatively in 12 hours on a full battery
OFF| Press and Hold button >2S
& flash 4 times| Sleep mode, no light output but can charge during daytime
Notes:
- Press and hold the button for more than 2s to wake up the light for the first time.
- The factory default setting for the operating mode is “6H”
- Press and hold this button for more than 2s to realize ON and OFF functions in sequence; Press this button in sequence to set the three modes 3H, 6H, 12H in sequence
- Luminaire light output decreases as battery capacity decreases
Application Notes:
- Installed in a place where the sun can reach it, avoiding shade from trees, buildings, etc., so that the solar panels receive as much sunlight as possible to charge the batteries
- 8 hours of charging in the sun for the first use
- 100% sunlight charging of the product, without any electrical connection
- The products can be stored up-to 6 months. In case it is required to store more than 6 months, it is recommended to recharge the product in bright daylight
- If the light is dim or does not light up, the battery may be low, please try again after charging in the sun
Signify(China)Investment Co.,Ltd.
BuildingNo.9,Lane888, TianlinRoad, Minhang District, Shanghai, China
Postal code: 200233 Philips and the Philips shield emblem are registered
trademarks of Koninkliike Philips N.Y
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>