Casino Software EMP 8×0 v5 Electronic Coin Selector Instructions
- June 9, 2024
- CASINO SOFTWARE
Table of Contents
Maintenance Instructions EMP 8×0 v5, v6 v7
Electronic Coin Selector
EMP 8×0 v5/EMP 8×0 v6/EMP 8×0 v7
– version 2.00 –
Safety Precautions
You are advised to observe the safety information during operation,
maintenance and repairing of electronic coin selectors of the EMP 800 series.
Failure to do so may result in warranty and other claims being excluded.
Whilst every care has been taken in the preparation of information contained
in this manual, wh Münzprüfer Berlin GmbH will not be liable for any
consequential loss or damage howsoever caused.
This manual is protected by copyright and all rights are reserved. Without
prior authorisation by wh Münzprüfer Berlin GmbH, no part of this manual may
be reproduced in any form by photocopy, microfilm or other processes nor may
it be transmitted in any form usable by data processing. The rights of
reproduction by lecture are also reserved.
The Company would be very grateful if any accidental inaccuracies could be
pointed out to us with any other constructive criticism which might lead to a
better understanding.
Introduction
The EMP 800 is an extraordinarily robust coin selector and operates relatively maintenance free. However, it should be cleaned at regular intervals especially if it is operating in an environment with high levels of dust, smoke or nicotine. The cleaning intervals are of course dependent on the level of air borne contaminants.
1.1. Cleaning
Modest use with minimum contaminant levels indicate the need to clean the top
of the coin path once a year. Open the coin path door and wipe the exposed
surfaces with an alcohol moistened cloth. Also lukewarm water with a little
washing-up liquid may be used. It is important that no dirt is pushed inside
the openings of the optical sensors. The light sensors may be cleaned with a
soft brush or air duster spray.
Make sure that the coin selector is without power during the cleaning.
Use a damp not wet – cloth. Under no circumstances liquid should run into the
coin selector.
Avoid solvent or abrasives which may affect the plastic material.
Never use an oily rag! Never lubricate the solenoid, hinge joints etc.!
1.2. Advanced Cleaning
In cases of a specially rough environment (e.g. car wash with coin extraction system or vacuum cleaners) it might be necessary to carry out some additional cleaning. Therefore the prism below the solenoid should be removed and carefully cleaned with a soft cloth.
Make sure that the thin connecting cables are not damaged.
Once the prism has been cleaned assemble the components in reverse order. Pay attention to the orientation of the prism. The bevel edges must be visible on the upside.
EMP8x0 v5, v6, v7
version 2.00
subject to technical modification
Documents / Resources
|
Casino Software EMP 8x0 v5 Electronic Coin
Selector
[pdf] Instructions
EMP 8x0 v5 Electronic Coin Selector, EMP 8x0 v5, Electronic Coin Selector,
Coin Selector
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>