AEinidi K700 3 In 1 Magnetic Wireless Fast Charger Instruction Manual
- June 9, 2024
- AEinidi
Table of Contents
AEinidi K700 3 In 1 Magnetic Wireless Fast Charger
HOW TO USE
INSTRUCTION
SPEIFICATION
Note: You need to equip your own PD charger.
For the fast and safe charge, using a Quick Charge 2.0 or 3.0 Wall Charger is
highly recommended. Other Chargers may not work well with this device.
Attention
- Please keep the charger away from water or other liquids.
- Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards, etc.) to avoid magnetic failure.
- This item is forbidden to be used on any mobile device with metal plates, as it wil cause extreme heat that may burm and/ or damage the device.
- Fast charge via the plug and USB charging cable (both support PD2.0, PD3,0 or Qc2.0, ac3.0)
- The standard temperature of wireless charger Ql is 130″F, but the temperature of our products should be controlled within 113°F. The charger wil cut off the current when abnormal heating occurs. Please contact us if any damage occurs
- We recommend that you tum off the power-consumption software before charging to effectively prevent the phone from overheating. When the temperature exceeds 113″F during charging, it is normal for the charging speed to slow down.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note 1: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- The minimum separation generally be used is at least 20 cm.