Towelrads 193122 Windsor Vertical 3 Column Traditional Radiator Installation Guide
- August 28, 2024
- TOWELRADS
Table of Contents
Towelrads 193122 Windsor Vertical 3 Column Traditional Radiator Installation Guide
Please keep this page for your online registration. No. FIRDSUN03V1.0
- Follow installation instructions carefully to ensure unit is properly attached to the wall.
- To avoid a possible fire hazard, it is ess,ential unit is mounted in accordance with guidelines stated in the instruction.
- Radiator is intended for indoor use only ,do not place radiator inside a shower, steam room ,or wherever unit would be exposed to water.
- These radiators can be very heavy products it is recommended you consult a qualified person if you are unsure about the suitability of the wall they are to be mounted on to take the weight.
TECHNICAL DATA
It should only be filled with water,and at a temperature below 100 °C(212°F).See table below for installation requirements.If the temperature exeeds 48°C(or 120°F),please install a warning sign near the product to avoid burning and scolding accidents.
Fill 3/4 Full: water only
Temperature: 0°C＜t≤100°C
Comments: If ambient temperature drops below 1°C, drain out the water to
prevent freezing.
Important
Wipe the surface clean with a soft,damp cloth.Never use abrasive cleaners on this product as they will damage the surface.
IMPORTANT CHILD SAFETY NOTE
Important: Please note that you are 100% legally responsible for your own child’s safety at home. Once the radiator is installed, it can become a hazard for children as a) This radiator is not designed to support unreasonable extra weight, such as that of a child, and b) The radiator becomes hot during use. Due to this, we must stress that you should not allow children to climb/grab/play with the radiator or rails, as this can cause accident or injury for the child,from heat,falling,or the radiator being pulled off the wall.
BEFORE INSTALLATION
- Observe all local plumbing and building codes.
- Shut off the main water supply.
- Read these instructions carefully to ensure proper installation.
- Read these instructions carefully to ensure proper installation.
Please check you have all of these items in the box.
NOTE: Accessory for bars ≤22 (＞22bar)
INSTALLATION PROCEDURE
-
Position the towel rail in desired location check for level and mark four equal positions for the brackets.
-
Drill holes in wall and insert wall plugs. N.B For false or studded walls different fixings can be purchased from your local DIY store.
-
Fix the wall brackets to the wall with screws provided and ensure a secure holding.
-
Wrap PTFE tape around blanking plug and bleeder valve and screw into top of radiator tighten with a spanner.
Apply PTFE tape to valves and screw into bottom of radiator tighten with a spanner.
- Rest radiator onto brackets and connect valves to household supply.
AFTER INSTALLATION
Use a screwdriver to open the air vent,open the valve and let the water rush
into the radiator.
Check all connection for leaks.
Once water overflows from the air vent,there is no air in the tube.
Use a screwdriver to close the air vent,turn on the valve and the radiator is
ready for use.
CARE & CLEANING
Radiators are made from steel with plating and should not be cleaned with corrosive or scouring cleaning agents.
TROUBLE SHOOTING
When your radiator doesn’t function,knowing basic radiator troubleshooting can save you from the stress and the hassles of a non-functioning radiator.Here is a guide to solve the most common problems associated with these radiators.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>