frient Smart Home Zigbee Electricity Meter For Norwegian HAN Meters Instruction Manual
- June 9, 2024
- Frient
Table of Contents
Smart Home Zigbee Electricity Meter For Norwegian HAN Meters
Instruction Manual
EMI Norwegian HAN
INSTALLATION MANUAL
Version 1.2
Product description
The EMI collects readings and information from your existing and already installed meters and sends the data to a Zigbee based gateway and further on to connected appliances. With this product you can follow your energy consumption through a display, on your computer or your mobile phone.
Precautions
Do not remove the product label as it contains important information.
Getting started
The EMI requires no special assembly and is powered by the electricity meter. The EMI is already equipped with a HAN cable which is easily attached.
- Insert the end of the cable into the HAN port on the electric meter. Consult your meter’s manual for the exact location of the port.
- The EMI will now start searching (up to 15 minutes) for a Zigbee network to join.
- Make sure that the Zigbee network is open for joining devices and will accept the EMI.
- While the EMI is searching for a Zigbee network to join, the LED flashes red.
- When the LED stops flashing, the EMI has successfully joined the Zigbee network.
Placement
- Place the device indoors at a temperature between 0-50°C.
- The EMI must be placed close to your electricity meter.
Mounting
- To mount the EMI first clean the desired surface before mounting.
- The EMI can be mounted either directly to the wall next to the meter, or if the meter is enclosed in a metal box, on the box itself, using the double stick tape, already applied on the back of the EMI. Press firmly to secure the device.
Resetting
Resetting is needed if you want to reconnect your EMI or if you need to
perform a factory reset to remove abnormal behaviour.
STEPS FOR RESETTING
- Open the casing of the device.
- Press and hold the menu button until the LED flashes red, then release the button again.
- After a successful reset the red LED will start flashing, which indicates network search.
Fault finding
- If the EMI does not send correct meter data, confirm that the connector is inserted correctly to the meter. If you still don’t get any data, contact your electricity provider, and assure that the HAN interface is enabled at your meter.
- In case of a weak or a bad signal, change the location of the EMI or strengthen the signal with a range extender.
- If the search for a gateway has timed out, a short press on the button will restart it.
CE certification
The CE mark affixed to this product confirms its compliance with the European Directives which apply to the product and, in particular, its compliance with the harmonized standards and specifications.
IN ACCORDANCE WITH THE DIRECTIVES
- Radio Equipment Directive (RED) 2014/53/EU
- Low Voltage Directive (2014/35/EU)
- RoHS Directive 2015/863/EU amending 2011/65/EU
Other certifications
- Zigbee Home Automation 1.2 compliant.
All rights reserved.
frient assumes no responsibility for any errors, which may appear in this
manual. Furthermore, frient reserves the right to alter the hardware,
software, and/or specifications detailed herein at any time without notice,
and frient does not make any commitment to update the information contained
herein. All the trademarks listed herein are owned by their respective
owners.
Distributed by frient A/S
Tangen 6
8200 Aarhus N
Denmark
www.frient.com
Copyright © frient A/S
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>