Shark NV100 Series Navigator Light FAQs
- June 9, 2024
- Shark
Table of Contents
Shark NV100 Series Navigator Light FAQs
This article contains the FAQs for the S3973 Series Shark® Lift-Away® Pro Steam Pocket® Mop. This supports the following product SKUs NV100, NV105, and NV106.
FAQs
General questions about using the vacuum:
How do I remove the handle to clean above floors?
Press the release button on the back of the handle and gently lift it off the
wand. Add an accessory and begin cleaning.
How do I remove the handle with extension wand to clean above floors?
Press the Wand Release button and pull up on the wand to detach it from the
pod.
How do I turn the vacuum off?
To turn the vacuum off, press the red power button on the vacuum pod to O,
power off.
General questions about maintenance:
How do I clean the filters and how often?
Make sure the unit is unplugged.
Pre- Motor Filters
Remove the dust cup and pull the flat foam filter out from the motor housing. Then remove the felt filter using the small ribbon pull-tab. Rinse filters thoroughly in lukewarm water until the water runs clear. Squeeze out excess water and let air-dry completely for at least 24 hours before replacing. Do not place filters in the dishwasher or washing machine. To replace inside the vacuum once dry, put the felt filter in first, then add the foam filter.
Hepa Filter
Remove the filter cover from the front of the vacuum by pulling the latch from under the motor housing. Remove the HEPA filter cartridge, pull off the pre- HEPA filter and rinse them both under lukewarm water, dirty side down, until the water runs clear. Allow the filters to air-dry completely for 24 hours. Once the filters are dry, snap them back together and place them back into the vacuum, then replace the cover by lining up the tabs on one side and swinging the door securely closed until it clicks into place
How do I empty the dust cup and how often?
Press the release button on the top of the dust cup handle. Tilt the dust cup
and lift it away from the vacuum body.
Hold the dust cup over the trash and press the bottom door release button on the front of the dust cup. The bottom lid will drop open. Tap gently to empty contents. Close the lid, pressing it until it clicks into place.
The dust cup should be emptied each time you vacuum and periodically during cleaning, when it appears full
How do I maintain the brushroll?
With scissors, carefully cut away any hair wrapped around the brushroll. Check
for any debris in the nozzle and remove if needed. brushroll. Check for any
debris in the nozzle and remove if needed.
Product Specifications:
Where is the product made?
The Shark Navigator Light Upright Vacuum is manufactured by our high-quality
vacuum manufacturing partners in China.
What is the weight of the vacuum?
The vacuum weighs less than 10.8 lbs
What are the dimensions of the vacuum?
The vacuum is 45.3 inches tall, 11.3 inches long, and 13.5 inches wide.
What is the dirt capacity of the dust cup?
0.8 Quarts
What is the length of the cord?
The cord is 25 feet long.
What is the Voltage?
120 Volts
What is the Wattage?
700 Watts
What is the Amperage?
5.8 Amps
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>