PHILIPS PADPE Antumbra Display User Interface User Guide
- June 9, 2024
- Philips
Table of Contents
PHILIPS PADPE Antumbra Display User Interface
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations
Installation Instructions
Federal Communications Commission (FCC)
Compliance Notice: Radio Frequency Notice – This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver. Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Any
modifications not approved by the manufacturer of this device could void the
user’s authority to operate this device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB-003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded. © 2022 Signify Holding. All rights reserved. Specifications are
subject to change without notice. No representation or warranty as to the
accuracy or completeness of the information included herein is given and any
liability for any action in reliance thereon is disclaimed. Philips and the
Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
All other trademarks are owned by Signify Holding or their respective owners.
- Do not connect inputs to mains.
- Disconnect power before connecting or separating modules.
- Refer to Service Guide for full cleaning recommendations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>