MIKRO Flash the Reference Design via Bootloader Instructions
- June 9, 2024
- MIKRO
Table of Contents
MIKRO Flash the Reference Design via Bootloader
How to flash the Reference Design via Bootloader
Step 1
Install Renesas Flash Programmer V3.09 or later: https://www.renesas.com/us/en/software-tool/renesas-flash-programmer- programming-gui#download
Step 2
Put Jumper on Pin 7 and Pin 9 of the Debug Interface.
Step 3
Connect the Device to the PC.
Step 4
Open Renesas Flash Programmer:
-
Open new Project: File >> New Project
-
Fill out the tabs:
- Microcontroller: RA
- Project Name: create your project name
- Project Folder: your project folder path
- Communication Tool: COM Port >> Tool Details: your COM Port number
-
Connect
-
Browse and select the wanted .srec file and Click “Start”
The .srec file is available at https://github.com/Broadcom/AFBR-S50-API/releases -
If flashing was successful, “operation completed” is displaying at the console. (as illustrated in the picture)
Step 5
Jumper needs to be removed or set to its initial position again (not flashing position) otherwise the board will not be functional in normal operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>