NOTHING BUT LEDS 1550391 Emergency Lights Running Man Combo Exit Sign User Guide

Table of Contents

NOTHING-BUT-LEDS-1550391-Emergency-Lights-Running-Man-Combo-Exit-Sign-
PRODUCT

SKU # 1550391
Output power : 4W
Lumens: 150+lm
CCT: 6000K-7000K
Injection- molded thermoplastic ABS housing
Charging Time: 24H
Discharging Time: 90 MIN
Input Volt: 120/347V/60Hz
Battery: 3.6V 1000mAh Ni-Cd Battery
IP Rating: IP20
LED: 14 LEDS+2*1.2W LED lamp head
Certiﬁcations: UL Listed
Warranty: (5 years warranty for the electrical parts and housing; 3 years warranty for battery)”

NOTHING-BUT-LEDS-1550391-Emergency-Lights-
Running-Man-Combo-Exit-Sign-FIG-1

NOTHING-BUT-LEDS-1550391-Emergency-Lights-Running-Man-Combo-
Exit-Sign-FIG-3

IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS

Review the diagrams thoroughly before beginning.
All electrical connections must be in accordance with local codes, ordinances, and the National Electric code.
Disconnect power at the fuse or circuit breaker before installing or servicing.
Do not use outdoors.
Do not mount in hazardous locations, or near gas or electric heaters.
Do not let power cords touch the hot surfaces.
Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
All servicing should be performed by qualified personnel only.
Allow the battery to charge for 24 hours before first use.

WIRING DIAGRAM (see Fig 1)

Assembly Lamp Heads (see Fig 2)

The fixture suitable for wall mounting, side mounting, ceiling mounting.

Open front cover and assemble 2 pcs lamp heads on the frame.
Knockout appropriate mount screw hole and cable hole, mount back plate on the wall after feed building AC supply cable into back plate(see Fig 3).
For ceiling and side mounting purpose, remove the mounting hole cover on the top or side of the unit, assemble the canopy (see Fig 4,5,6).
Attach crossbar to junction box, set the longer blade of crossbar touching the J-Box.
Route the proper wires through mounting hole out of housing.
Make electrical connections inside the J-Box as wiring diagram.
Push excess wire into J-Box, use screws tighten canopy to crossbar so that canopy is securely fastened and tight against the wall.
Attach battery connector to PC board, restore front cover on unit, adjust position of lamp heads as need.
If pictogram direction assembled not suitable, pictogram can take out for change direction or replace pictogram, and then insert into the diffuser easily(See Fig 7).

Connecting Remote Heads (see Fig 8)

Using 1 pc battery, no remote capability.
Using 2pcs battery with remote capability.
Connect the remote heads extension wire to the remote wire, yellow is positive(+), and purple is negative(-). connect wires using wire nuts.
Remote capability reference below:
KDR-880-(HO)2RC has max. 3.6V 2W remote capabilities.
KDR-880-4RC has max. 3.6V 4W remote capabilities.