Free The Tone SILKY GROOVE SG-1C Compressor Effects Pedal User Guide
- June 9, 2024
- FREE THE TONE
Table of Contents
SILKY GROOVE SG-1C Compressor Effects Pedal
User Guide
SILKY GROOVE SG-1C Compressor Effects Pedal
Thank you for choosing a Free The Tone product. Please read this user’s manual thoroughly to ensure that you’ll benefit fully from the advanced features, performance, and reliability your Free The Tone product is designed to provide.
About the Product
The SILKY GROOVE is a compressor featuring a natural and smooth sound. This
unit can provide you with a broad range of sound making from heavily
compressed effect sound without dry signal to fast and strong tone composed
mostly of dry sound. Setting the DRY MIX knob to the leftmost position, the
unit outputs the effect sound only. Turning the knob clockwise increases the
dry sound. When the knob is at the 12 o’clock position, the proportion of the
effect to dry sounds becomes nearly 1:1. Please note that turning the knob
fully clockwise does not make the dry sound 100%. The SUSTAIN knob adjusts the
depth of the compression. Turning the knob clockwise makes the compression
deeper. The ATTACK knob sets the attack of the sound. By turning the knob
counterclockwise, the unit operates to suppress the attack sound more strongly
and turning it clockwise makes this suppression weaker. The LEVEL knob changes
the output level when the effect is turned on.
The SILKY GROOVE is also equipped with FREE THE TONE’s original HTS (Holistic
Tonal Solution) circuit that protects the bypassed guitar signal from becoming
too thin or losing tonality.
The LED indicator on this unit functions not only to show the effect on/off
status but also to monitor the battery voltage. When the voltage becomes lower
than about 6 volts, the LED starts to dim. Although effect sound is still
output in this state, we recommend to replace the battery with a new one to
keep full performance of this product.
NOTE: No battery is shipped with this package. Please prepare a suitable
one separately.
Precautions
Inserting or removing a plug from the input jack while the unit’s output is
connected to an amplifier/speakers that is turned on can cause noise that can
damage the speakers.
If the unit malfunctions or behaves abnormally, cease operation immediately
and refer the problem to the supplier. If the unit will not be sed for an
extended period of time, remove the battery to prevent damage due to chemical
leakage from the battery. When the battery voltage drops too low for proper
operation the effect sound may become weak, the output level may drop, or no
output will be produced at all. Be sure to replace the battery as soon as
possible if such symptoms occur.
Main Specification
- Input impedance: min. 500kΩ
- Output load impedance: min. 10kΩ
- Controls: SUSTAIN, ATTACK, DRY MIX, LEVEL
- Terminals: 2 x 1/4″ standard phone jacks (input, output), DC9V input jack (for AC adapter connection)
- Power supply: 9-volt PP3 battery, 9V DC center negative polarity
- Current consumption: 7 mA
- Dimensions (W x D x H): 72 x 115 x 50 mm (incl. protuberances such as footswitches, jacks, etc.)
- Weight: approx. 230 g (excl. accessories)
- Accessories: Warranty card, manual, 4 x rubber feet
Specifications and appearance are subject to change for improvement without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>