Buyers 8891400 Series LED Mini Strobe Installation Guide

June 9, 2024
Buyers

Buyers 8891400 Series LED Mini Strobe

Surface Mount

  • To +VDC (fuse@ 1A)
  • TO Chassis Ground

For Synchronization

  1. Connect YELLOW wires of all heads together for synchronization (all heads must be set at the same pattern)

Buyers-8891400-Series-LED-Mini-Strobe-fig-2

For Simultaneous or Alternating Flash

  1. Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping Mode; lighthead will display short (single or double) flashers:
    • Single flash = Group 1
    • Double flash = Group 2
  2. Remove YELLOW wire from +VDC and momentarily apply to +VDC to change Groups:
    • Heads in the same Group flash together.
    • Group 1 Heads alternate with Group 2 Heads

For Flash Patterns
Momentarrily apply  + VDC to YELLOW wire:

  • Once for next pattern
  •  Quickly three times for pattern Zero
    Note: Flash Pattern is preset to #0 Quint Flash

Buyers-8891400-Series-LED-Mini-Strobe-fig-6

Adhesive Mount

  1. Select mounting location and clean surface
  2. Peel one side of adhesive and apply to lighthead base
  3. Peel other side of adhesive and secure lighthead firmly to the mounting surface
    Note: Optimum adhesive strength is achieved after 24 hours.

Screw Mount

  1. Select mounting location.
  2. Mark and drill mounting holes.
  3. Secure lighthead to mounting surface with supplied screws.

Buyers-8891400-Series-LED-Mini-Strobe-fig-4

Bracket Mount

  1. Select mounting location.
  2. Place rubber pad to bottom of light head base
  3. Place light head to the mounting surface.
  4. Align top holes of bracket onto the light head base alignment points.
  5. Secure light head with supplied screws from the bottom of the bracket

Buyers-8891400-Series-LED-Mini-Strobe-fig-5

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals