Clarkdietrich 51026 Crack-Tape 2-in x 50-ft Perforated Joint Tape Instruction Manual
- June 9, 2024
- ClarkDietrich
Table of Contents
51026 Crack-Tape 2-in x 50-ft Perforated Joint Tape
Instruction Manual
Installation:
- Run your taping knife over the surface of the damaged area to remove any loose plaster or drywall debris. Measure damaged area and cut Crack-Tape using a scissors or utility knife. For corner applications, fold in half at center crease and adjust to desired angle. Properly mix all-purpose compound or quick-set joint compound per manufacturer’s directions. If applying Crack Tape over painted surfaces, add Strait-Flex Super-Bond to enhance bondability.
- With a 5″ or 6″ taping knife, apply a smooth, liberal coat of all-purpose compound to corner.
- Press Crack-Tape into the wet compound. Adjust if necessary to create a straight line.
- Wipe down tight to surface with taping knife using even pressure.
- Immediately apply a light skim coat of compound over surface of Crack-Tape. Wipe down smooth. Let dry completely over several hours or overnight.
- Use taping knife to detect and remove any high spots or dried clumps of compound.
- With a 6″ or 8″ taping knife, apply a second coat of compound directly over Crack-Tape feathering the compound beyond previous coat. For drywall, lightweight compound used in this step makes sanding much easier. Let dry completely over several hours or overnight.
- If further feathering is required, apply another coat of compound using a 6″ or 8″ taping knife. Extend the compound on both sides by starting from the middle of Crack-Tape. Let dry completely over several hours or overnight.
- Sand lightly with 120 grit sandpaper. Crack-Tape will not fuzz-up like paper or mesh tapes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>