ClarkDietrich BS-10 Big Stick Composite Corner Bead Instruction Manual
- June 8, 2024
- ClarkDietrich
Table of Contents
ClarkDietrich BS-10 Big Stick Composite Corner Bead
DIMENSION
Installation
-
Measure wall height and subtract 1 /2″. Measure and cut
Big-Stick using a scissors or utility knife. Cut the ends of
Big-Stick at a 45° angle. -
With a 4″ or 5″ taping knife, apply a smooth, liberal coat of all-purpose compound to corner.
-
Press Big-Stick into the wet compound. Adjust if necessary to create a straight line.
-
Wipe down tight with taping knife using a little additional pressure on the outer edges of Big- Stick. Immediately apply a light skim coat of compound over surface. Wipe down tight and smooth. Let dry completely over several hours or overnight.
-
With a 6″ or 8″ taping knife, apply your final coat of compound feathering the compound beyond previous coat. Let dry completely over several hours or overnight.
-
Sand lightly with 120 grit sandpaper. Big-Stick will not fuzz-up like paper or mesh tapes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>