GABRIEL SCOTT Luna Stunning Modular Glass Chandelier Installation Guide

Table of Contents

GABRIEL-SCOTT-Luna-Stunning-Modular-Glass-Chandelier-
PRODUCT

Suspended mount only.
Certified electrician recommended for electrical installation.
Minimum 2 people recommended for installation.
Terminal Block not included. Installation may require advice froma qualitied person.
Junction box rated for minimum of 100lbs or structural blocking required to support fixture.
Structural blocking required at monopoint locations, adequate drywall plugs may be substituted.
Far all LED fixtures, use only with class 2 power unit.
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualitied person. Contact manutacturer tor service.
For controllable luminaires, the classitication ot insulation that has been maintained between LV supply and control conductors shall be provide… basic insulation, reintorced insulation etc.

Provided supplies

Required tools and hardware

Screwdriver
Drywall anchors suitable for 25lbs for mono points
4x 2-pole wiring terminals, screws or screwless, 12- 18AVwG (10-2.5mm2) rated for 60OV, 15A/ ex WAGO 222-412
LED driver; Input: local line voltage, output 24Vdc SELV, 5A, max 60 watt class 2 LED driver

STEP 1

Tape provided a 1:1 printed template to the ceiling at the desired location and install all male mono points at the cross indicated on the template.
Note: Fach anchor point should be capable of supporting 25|lbs and therefore adequate blocking or toggle bolts are required for proper support at the location of each male monoprint.

STEP 2

Begin hanging the fixture by screwing the female monopoints of each tube section onto the corresponding male monopoints on the ceiling. Be sure to adequately support al elements during installation.
STEP 3 Insert wire way in the canopy, as shown.
STEP 4 Insert the aircraft cable in the grip lock and the coaxial cable through the wire way
STEP 5 Using wire terminals, connect the LED driver to the Luna Fixture (Maximum distance 100, Use 12-18AWG (1.0-2.5mm)). The outer metallic casing ot the coaxial cable is Negative (-) and the black wire is Positive (+). Finally install the universal T-bar and then secure the canopy to the T-bar using the screws provided. The drop height should already be set to the correct height with a grip lock.
STEP 6 Install the volumes by removing the aircratt cable from the plunger and then sliding the volume onto the tube, finish by re-inserting the aircratt cable to properly support the texture. Be sure to properly support the fixture during the step especially when the aircraft cables are disconnected