beurer HL 76 SatinSkin Epilator Wet and Dry Instruction Manual

beurer HL 76 SatinSkin Epilator Wet and Dry Instruction Manual

Read these instructions for use carefully. Observe the warnings and safety notes. Keep these instructions for use for future reference. Make the instructions for use accessible to other users. If the device is passed on, provide the instructions for use to the next user as well.

1. INCLUDED IN DELIVERY

Check that the exterior of the cardboard delivery packaging is intact and make sure that all contents are present. Before use, ensure that the device and accessories have no visible damage and all packaging material is removed. If you have any doubts, do not use the device and contact your retailer or the specified Customer Services address.

• 1 Epilator Wet & Dry
• 1 Epilator attachment
• 1 Glide attachment (for epilator attachment)
• 1 Precision attachment (for epilator attachment)
• 1 Attachment holder (for shaver attachment)
• 1 Shaver attachment
• 1 Trimming attachment (4 mm)
• 1 Protective cap
• 1 Storage bag
• 1 Cleaning brush
• 1 USB-C charging cable
• 1 Charging and storage station

2. IMPORTANT SAFETY NOTES

⚠ WARNING

• The device must only be used for the purpose for which it was de-signed and in the manner specified in the instructions for use.
• The device is only intended for domestic/private use, not for commercial use.
• This device may be used by children over the age of 8 and by people with reduced physical, sensory or mental skills or a lack of experience or knowledge, provided that they are supervised or have been instructed on how to use the device safely, and are fully aware of the consequent risks of use.
• Children must not play with the device.
• The hand-held part must be disconnected from the connection cable before it is cleaned in water.
• When using the device in the bathroom, unplug the plug after charging as water in the vicinity constitutes a danger, even when the device is switched off.
• If the device should fall into water despite following all safety precautions, immediately pull the mains plug from the socket! Do not reach into the water! Risk of electric shock!
• Cleaning and user maintenance must not be performed by children unless supervised.
• As an additional safety measure, we recommend the installation of a residual-current-operated protective device (RCD) with a rated operational current not exceeding 30 mA in the bathroom circuit.
• Under no circumstances should you open or repair the device yourself, as correct functioning of the device can no longer be guaranteed should you do so. Failure to observe this will invalidate the warranty.
• Cleaning and user maintenance must not be performed by children unless supervised.
• The device may only be supplied with protective extra-low voltage.
• Danger of suffocation! Keep packaging materials away from children.
• Do not use the device if you have sunburn, open wounds, eczema or cuts.
• In the event of a fault or damage, have the device repaired by a certified specialist workshop.
• Protect the device and its accessories from impacts, humidity, dirt, marked temperature fluctuations and direct sunlight.

Intended use
The Epilator Wet & Dry (hereinafter referred to as the device) is intended exclusively for removing human body hair. Do not use the device on animals or objects!

⚠ Notes on handling batteries

• If your skin or eyes come into contact with fluid from a battery cell, wash the affected areas with water and seek medical assistance.
• Protect batteries from excessive heat.
• Risk of explosion! Never throw batteries into a fire.
• Do not disassemble, split or crush the batteries.
• Batteries must be charged correctly prior to use. The instructions from the manufacturer and the specifications regarding correct charging in these instructions for use must be observed at all times.
• Fully charge the battery prior to initial use. In order to achieve as long a battery service life as possible, fully charge the battery at least 2 times a year.
• The device contains batteries that are not replaceable.

3. SIGNS AND SYMBOLS

The following symbols are used on the device, in these instructions for use, on the packaging and on the type plate for the device:

4. DEVICE DESCRIPTION

The corresponding drawings are shown on page 3.

1. Base device
2. ON/OFF button
3. Battery level indicator
4. Charger
5. Protective cap
6. Epilator attachment
7. Glide attachment (for epilator attachment)
8. Precision attachment (for epilator attachment)
9. Attachment holder (for shaver attachment)
10. Shaver attachment
11. Trimming attachment (4 mm) (for shaver attachment)
12. Release button

5. USAGE

Commissioning/charging the battery
The device should only be charged with a mains adapter with an output of min. 1 A.

1. Charge the device for approx. 2 hours before initial use. You can either charge the device directly (Figure A ) or connect it to the charging station (Figure B ). Connect the charging station or the device to a suitable mains adapter (mains adapter not included in delivery scope) or via a device with a suitable interface.
2. The battery level indicator 3 flashes during charging. Once the battery is fully charged, the battery level indicator 3 stays on continuously. The device is now ready for use. One charge is sufficient for approx. 40 minutes of operation.

Epilating

1. Press the ON/OFF button 2 to switch on the device.

2. To increase the speed setting, press the ON/OFF button 2 again.

3. Cleanse skin before epilation to avoid redness. Ideally, epilate after or during the shower to make it easier to pull out your hair. The device can be used both on dry skin and in the shower or in the bathtub.

4. Place the device vertically on your skin. Guide the device slowly, steadily and without pressure over the skin against the direction of hair growth (Figure C ). As hair doesn’t always grow in one direction, guide the device over the skin in various directions. For best results, use your free hand to tighten the skin to make the hair stand up. For thorough epilation, the hair should be about 2 to 5 millimetres long.
   Be aware that the underarm and bikini areas may be particularly sensitive to pain at first. We therefore recommend that you use the lowest speed setting upon initial use. The pain will lessen with repeated use. As skin in this area is particularly sensitive after epilation, do not use any substances that might irritate the skin such as alcohol-based deodorant.

5. To switch off the device, press the ON/OFF button 2 again. If the battery level indicator 3 flashes red during battery operation, the battery is almost empty.

6. You can also attach the following two attachments to the epilator attachment 6 : Glide attachment 7 : For gentle gliding over skin during epilation. To do this, attach the glide attachment 7 to the epilator attachment 6 (Figure E ). Precision attachment 8 : For epilation of very sensitive areas. To do this, attach the precision attachment 8 to the glide attachment 7 (Figure F ).

Shaving/trimming

1. You can also use the device for shaving or trimming: Shaver attachment 10: For a gentle shave of the skin. Trimming attachment 11: For shortening hair to 4 mm. To do this, place the trimming attachment 11 onto the shaver attachment 10 (Figure H ).
2. Press the release button 12 and remove the epilator attachment 6 from the base unit 1 (Figure D ).
3. Place the attachment holder (for shaver attachment) 9 onto the base unit 1 .
4. Insert the shaver attachment 10 into the attachment holder (for shaver attachment) 9 (Figure G ).

Travel lock
The device has a travel lock. If the travel lock is activated, it is not possible to switch on the device. The travel lock prevents the device from switching on unintentionally (e.g. when being carried in a suitcase).

1. To activate the travel lock, press and hold the ON/OFF button 2 for 3 seconds. The battery level indicator 3 flashes. The device is now locked. If you press the ON/OFF button 2 while the travel lock is activated, the battery level indicator 3 flashes briefly.
2. To deactivate the travel lock, press and hold the ON/OFF button 2 again for 3 seconds. The battery level indicator 3 flashes. The device is now unlocked.

6. CLEANING AND MAINTENANCE

⚠ Risk of electric shock!
Unplug the device each time before cleaning. Clean the device using only the methods specified.

1. Do not use any abrasive cleaning products or hard brushes.
2. For better cleaning, the glide attachment 7 can be removed from the epilator attachment 6 after epilation (Figure E ). After shaving, remove the shaver attachment 10 from the attachment holder 9 (Figure G ).
3. Then remove the epilator attachment 6 / the attachment holder (for shaver attachment) 9 from the base unit 1 (Figure D ).
4. Use the cleaning brush to remove coarse hair from the epilator attachment 6 / attachment holder (for shaver attachment) 9 / the shaver attachment 10.
5. The product is waterproof. Thoroughly clean the epilator attachment 6 / the attachment holder (for shaver attachment) 9 / the shaver attachment 10 and the base unit 1 under running water.
6. Do not use the device again until it is completely dry.

7. ACCESSORIES AND REPLACEMENT PARTS

To purchase accessories and replacement parts, please visit www.beurer.com or contact the service address for your country (see the service address list). Accessories and replacement parts are also available from retailers. Replacement recommended every 12 months.

8. DISPOSAL

For environmental reasons, do not dispose of the device in household waste at the end of its service life. Dispose of the device at a suitable collection point in your country. Dispose of the device in accordance with the EC Directive on Waste Electrical and Electronic Equipment (WEEE). If you have any questions, please contact the local authorities responsible for waste disposal. Batteries must not be disposed of in the household waste. They may contain poisonous heavy metals and are subject to special refuse treatment. The codes below are printed on batteries containing harmful substances:
Pb = battery contains lead
Cd = battery contains cadmium
Hg = battery contains mercury

9. TECHNICAL SPECIFICATIONS

The Declaration of Conformity for this product can be found at the following address: https://www.beurer.com/web/we- landingpages/de/cedeclarationofconformity.php

10. WARRANTY

Further information on the warranty and warranty conditions can be found in the warranty leaflet supplied.

Beurer GmbH • Söflinger Str. 218 • 89077 Ulm (Germany) www.beurer.com • www.beurer- gesundheitsratgeber.com www .beurer-healthguide.com

References

• Beurer Gesundheitsratgeber
• Beurer Health Guide
• Beurer — Beurer North America
• MDR & Zertifikate

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>