Remote Controls 8009 2.4G Wireless Digital Remote Control Instructions
- June 8, 2024
- Remote Controls
Table of Contents
Controls 8009 2.4G Wireless Digital Remote Control
Instruction manual
Smart fan light controller specification
Product Introduction :
This product uses 2.4G wireless digital remote control technology, remote
control one-to-one control, simple and convenient operation, strong anti-
interference ability.
Technical Parameters :
Wall switch segment sequence : All bright/white light/yellow light
Input voltage : 200V-
240V AC50Hz
Power factor : >0.9
Output voltage : 90-200VDC
LED Output Power : 25-60W
Motor rated power : <25W
Controller efficiency : >84%
Wind velocity : 1-6 gears
Timing : 1 hour / 2 hours
Receiving method : RF2.4G
Remote control distance : 8-20 meters
Remote control battery : Number 7 1.5V X2
Remote control matching code :
Turn on the power and press and hold the light switch button for a long time
within 5 seconds of the light on,When you hear a beep or a light flashes, the
code match is successful.If you need to match the code a second time, you need
to wait 30 seconds before turning on the power and repeat the above operation.
CAUTION:
Theelectronicswitchisnotanisolatedproductandneedsto be
operatedbyprofessionalpersonnelduringinstallation.
Theelectronicswitchistriggeredby the remote control, and the
wirelessfrequencyoftheremotecontroltransmitteris2.4GHz.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>