iStyle LED-AnaC LED Mirror Cabinet Instruction Manual
- June 8, 2024
- ISTYLE
Table of Contents
Installation, Care Guide
LED Mirror Cabinet
Model Code:LED-AnaC
INSTALLATION INSTRUCTION
Size:610813120mm/762813120mm/914813120mm
• Mirror diagram
• Tools required
Two persons required for correct installation
• Before Installation
- Please read these instructions carefully before installation.
- Installation should be only carried out by a qualified professional.
- ENSURE THAT ELECTRICAL CONNECTIONS ARE TURNED OFF AT THE CONSUMER UNIT OR FUSE BOARD BEFORE INSTALLING OR CARRYING OUT ANY MAINTENANCE.
- Please take note of the Tools Required prior to commencement of any installation procedures.
- Follow the Installation Steps on Page 2 to ensure that the correct installation method is adhered to. Please also read all operating and safety instructions before commencing any installation to ensure complete understanding of the installation procedure.
- All information provided by these guidelines are based on the latest technical product information. We reserve the right to change the product characteristics, packaging or supply without prior notice.
- These guidelines include maintenance and cleaning advice.
- THIS PRODUCT IS FOR INDOOR USE ONLY.
WARNING: There may be hidden dangers to people or product during installing. In order to avoid trapping fingers, please pay attention to the open and closed door position.
WARNING: Do not use any acidic or alkaline cleanser or alcohol on this product. Please clean with a damp soft cloth.
WARNING: Keep away from water and electricity when hanging on wall.
IMPORTANT: This product is a one-way hanging mirror. Please make sure that there are no obstacles (i.e. electrical cable / water pipework) inside the wall before commencing installation procedure.
WARNING: This product is fragile – it should be installed by a professional person with suitable protective equipment, as listed in the Tools Required above.
• Material Statement
[1] Mirror cabinet 1pc
[2] Side panel 2pcs
[3] Holder 4pcs
[4] Upper bracket 3pcs
[5] Bottom bracket 1pc
[6] ST435 screw 6pcs
[7] Wall plus 6pcs
[8] Screw cap 6pcs
[9] ST48 screw 4pcs
[10] Cover plate 1pc
• Installation Steps Hanging installation
STEP 1
1. Mark holes based on the desired location, then drill holes and fix mounting bar on the wall
STEP 2
2. Put the cabinet on the mounting bar, insert the top clips on the top of cabinet, fix it with screw
STEP 3
3. Insert side kits as picture ,connect the power wire
- Power cables position Input:120v, 50/60Hz
- Anti-fog / Color / dimming and light switch
Tear the tape
STEP 4
4. Adjust door position accordingly.
