MAIDEN HOME The Wythe Bed Installation Guide

Table of Contents

MAIDEN-HOME-The-Wythe-Bed-PRODUCT

Connecting Side Rails to Headboard:

Insert the pre-attached rail fastener into the headboard fitting and press down firmly to lock it in place.

Connecting Side Rails to Footboard:

Insert the pre-attached rail fastener into the footboard fitting and press down firmly to lock it in place.

Attaching Center Support Legs:

Screw the center support legs into the center support rail, with the metal T-nuts facing upward.

Placing Center Support Rail:

Place the center support rail inside the bed frame. Adjust the glides on the center support legs as needed to ensure they are straight and flush to the floor.

Installing Slats:

Place the slats inside the bed frame, ensuring they fit into the slat pocket which is designed to be slightly wider for easy assembly.

Frequently Asked Questions

Q: How many people are required for assembly?
- A: Assembly requires 2 people for proper and efficient setup.
Q: How many slats do Queen, King, and California King beds have?
- A: Queen and King beds have 14 slats, while California King beds have 15 slats.
Q: Should I disassemble the bed before moving it?
- A: Yes, if you need to move the bed for any reason, including installing a rug beneath it, it is recommended to disassemble it first and then reassemble it in the desired position.

MAIDEN-HOME-The-Wythe-Bed-FIG-1

To connect each side rail to the headboard, insert the pre-attached rail fastener into the headboard fitting and press down firmly to lock it in place.
To connect each side rail to the footboard, insert the pre-attached rail fastener into the footboard fitting and press down firmly to lock it in place.
Screw the center support legs into the center support rail, with the metal T-nuts facing upward.
Place the center support rail inside the bed frame. Adjust the glides on the center support legs as needed, ensuring the legs stand straight and are flush to the floor.
Place the slats inside the bed frame. Note that the slat pocket is designed to be slightly wider than the slat for ease of assembly.

The illustrations below display the various configurations of the Wythe bed

MAIDEN-HOME-The-Wythe-Bed-FIG-9

Review the checklist below to ensure your Wythe bed is properly assembled

Ensure all slats are present.
Ensure all slats are lying flat.
Ensure all hardware is firmly connected.
Ensure center support legs are level.
Ensure the mitered corners are flush with each other.
Should you need to move this piece for any reason— including installing a rug beneath it—disassemble it first, then reassemble in the desired position.