Columbia LIGHTING CFP Series CFP14-4035 Edge-LIT Flat Panel Instruction Manual

June 4, 2024
Columbia LIGHTING

Columbia LIGHTING CFP Series CFP14-4035 Edge-LIT Flat Panel

Columbia-LIGHTING-CFP-Series-CFP14-4035-Edge-LIT-Flat-Panel-product-
image

NOTE: Components shown in images are representative only and may vary based on the configuration ordered.
CAUTION Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.
WARNING If any special control devices are used with this luminaire, follow the instructions carefully to assure full compliance with NEC requirements. If there are any questions, contact a qualified electrical contractor.
WARNING This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

INSTALLATION METHOD 1: RECESSED MOUNTING

  • STEP 1
    Raise unit into ceiling. Cross tees may need to be trimmed when fixtures are installed in certain applications. For instance when installing a 2×4 recessed troffer into a 2×2 ceiling grid the cross tees would need to be trimmed or a zero clearance cross tee utilized.

  • STEP 2
    Bend T-bar clips into position.

INSTALLATION METHOD 2: LUMINAIRE FITTING

The luminaire fitting models are CFPSMK14 / CFPSMK22 / CFPSMK24

  • STEP 1
    Snap corner bracket to extruded rails, making sure that mounting flanges are on opposite sides.

  • STEP 2
    Attach frame to ceiling structure.
    Columbia-LIGHTING-CFP-Series-CFP14-4035-Edge-LIT-Flat-
Panel-04

  • STEP 3
    Remove one non-mounting frame side and slide in flat-panel. Make all electrical connections using appropriate fittings.
    Columbia-LIGHTING-CFP-Series-CFP14-4035-Edge-LIT-Flat-
Panel-05

  • STEP 4
    Reinstall frame side to complete.

WIRING CONNECTION

Wiring connection of both installation methods are the same

  • STEP 1
    Open access plate. Use knockouts to connect power access using appropriately- sized electrical fittings.

  • STEP 2
    Make wiring connections.
    Columbia-LIGHTING-CFP-Series-CFP14-4035-Edge-LIT-Flat-
Panel-08

LUMEN SELECTABLE INSTRUCTIONS

Different lumen levels can be achieved by setting the switch on the driver cover to different positions.

  • For 38W Product
    2800/3300/4000 Lumens

  • For 52W Product
    3400/4100/5500 Lumens|

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals