MULTIVERSE PTTCC004 Modular Tenement Instruction Manual
- June 8, 2024
- MULTIVERSE
Table of Contents
MULTIVERSE PTTCC004 Modular Tenement Instruction Manual
Assembly Instructions
Assemble the top (cable+plate) and the bottom of the neons separately and then
add the top piece to the bottom one.
Glue the top roof pieces to the bottom ones as shown, covering the holes.
Start the assembly of the main module with this piece.
Add the fioor piece to the model as shown (with the narrow protrusion in line
with the wall and the wide protrusion on the opposite end).
Add the wall with the door to the mod
Add the rear wall to the model as shown.
Add the rear wall to the model as shown Add all the narrow steps to the wall
with the entrance as shown (with the slanted side pointing outside).
Add this wall to the model. If the steps don’t line
up with the holes, place your finger behind them and push them slightly until
all the steps sit firmly between two walls
Glue the topmost step to the stairway as shown.
Remove the protective film and place the lower protrusion on the door into the
hole in the lowest step. Place the hinge on top of the door and carefully push
it into the slit.
fie assembled hinge should look like this
Add the two corner pieces to the model as shown.
Add this wide wall piece to the model.
Add the external wall piece with window to the other side of the module.
Add the fioor support piece to the model as shown here.
Glue the bar with hazard stripes to the front of the model as shown.
Place the first fioor piece inside and slide it under the bottom hinge.
Add the second half of the fioor to the model.
Place the fioor hatch into the hole in the fioor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>