BEDSURE BS-HB7284 Electric Blanket Full-Twin Size User Manual
- June 8, 2024
- Bedsure
Table of Contents
BEDSURE BS-HB7284 Electric Blanket Full-Twin Size
INTRODUCTION
Thank you for purchasing the Comfortable Flannel Heated Throw Blanket. Please read this user manual carefully and keep it in a safe place for future reference. If you need any assistance, please contact our support team with your product model number and Amazon order number.
INCLUDED
- 1 x Heated blanket
- 1 x Hand-held controller
- 1 x User manual
( Note: Please check first to make sure the product is complete without any damage. If you have any doubt, please do not use and contact us.)
Product Specifications
IMPORTANT INSTRUCTIONS
DO NOT DESTROY
READ INSTRUCTIONS CAREFULLY
- Be sure to read carefully the accompanying instruction booklet before using this bedding.
- Do not use this bedding with an infant, a helpless person, or anyone insensitive to heat, such as a person with poor blood circulation.
- Do not tuck in the wired area of this bedding.
- Do not route electrical cords between the mattress and box spring. Do not allow the cords to be pinched.
- Keep the control away from drafty areas that may become damp or wet such as an open window.
- Do not use pins – They may damage the electric wiring.
- Be sure that this bedding is used on an alternating-current supply circuit of the proper voltage.
- Turn off or unplug when not in use.
- Excessive heating may result from folding bedding, other than a mattress, when in actual use.
- If improper operation of this bedding is observed, discontinue its use immediately and consult the manufacturer or the dealer regarding its repair.
- Do not use with rocking chairs, recliners, chairs with casters or wheels, or other furniture subject to movement.
- Do not tuck the blanket or supply cord in a sofa or other furniture. All portions of the blanket or controller should be visible at all times.
- Wrapping of cord around the controller may damage the cord. Loop loosely when storing.
- Do not use dry-cleaning fluid on this bedding, cleaning solvents may have a deteriorating effect on the insulation of the heating element.
- Wash – Do not dry clean.
- Household use only.
- Save these instructions.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 ofthe FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
NORTH AMERICAN MODELS WITH POLARIZED PLUGS:
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way. If the plug fits loosely into the AC outlet or if the AC outlet feels warm do not use that outlet.
PRODUCT DIAGRAM
TEMPERATURE SETTING
CONTROLLER COMPONENTS & FUNCTION DESCRIPTION
-
Display
-
ON/OFF Button
Turn it on with the switch button, the default level is standby level 01, press the “+” “-” button to regulate the setting up to level highest 06. -
Time Setting Button
Press the time setting button, and the display lasts for 8 hours by default, press the “+” “-” button to adjust the timing, If there is no operation after flashing for 3 seconds, it will return to the previously set heating level. -
+ and – Buttons
“+” and “-” Buttons: Press the “+” and “-” buttons to adjust the heating level（01-02-03-04-05-06）and the timing (1H-2H-3H-4H-5H-6H-7H-8H-9H-10).
CAUTION
- Do not plug into the wall outlet until you have connected the controller cord to the product.
- Caution: the cord must be completely connected a risk of fire could occur with a loose connection
- Check with your healthcare provider before using a pacemaker or any medical devices
WARNING: This product is equipped with a SAFETY SYSTEM. This sensor technology prevents the blanket Please note that for safety, the product could not be operated any longer after the malfunction. If the overheat protection is activated, please contact us.
QUESTIONS & ANSWERS
CLEANING AND MAINTENANCE
Warning
- Before cleaning, always remove the mains plug from the outlet first.
- Disconnect the controller from the product.
CLEANING
- Soak the product for 15 minutes in mild soap and cool water.
- Machine wash on a gentle cycle in water at 30°C(86°F) for 2 minutes or hand wash.
- Rinse with fresh, cool water.
- Machine dry on a gentle, cool cycle or hang to dry. (Immediately after washing, reshape the product to its original dimensions and spread it out flat on a clothes horse or clothesline.)
MAINTENANCE
- Store the product only after it cools down completely and it is dry completely.
- Loop the cord loosely.
- Store in an airy, dry environment.
WASHING INSTRUCTIONS
Presoak for 15 minutes in mild soap and cold water. Machine wash in mild soap and cold water on slow cycle for 2 minutes. Rinse in fresh cold water. Spin dry. Stretch to the original size. Do not put through a wringer.
DRYING INSTRUCTIONS
For best results,air dry over two parallel lines. Do not use clothes pins. Machine dry caution: Do not use commercial dryers or dryers at your local laundromat. Preheat the dryer in the low-temperature setting for 2 minutes. Add electric blanket and tumble dry for 10 minutes. Remove while still damp and stretch to the original size. Air dry over a line or shower rail.
CAUTION
- DO NOT SUBMERGE THE CONTROLLER IN WATER. THE CONTROLLER MUST NEVER CONTACT WATER OR OTHER LIQUIDS DIRECTLY. TO CLEAN THE CONTROLLER, USE A DRY, LINT-FREE CLOTH.
- DO NOT DRY CLEAN AS DRY CLEANING SOLVENTS MAY DAMAGE THE WIRES.
- DO NOT CHEMICALLY CLEAN (WITH BLEACH OR CLEANING FLUIDS).
- DO NOT USE A WRINGER.
- DO NOT USE CLOTHESPINS.
- DO NOT IRON OR WRING OUT.
- DO NOT USE MOTHBALLS OR SPRAYS OF ANY KIND.
- DO NOT RE-CONNECT OR USE UNTIL COMPLETELY DRY.
- DO NOT WASH THE CORD OR PUT THE CORD INTO WATER.
- PLEASE NOTE THAT FREQUENT WASHING OF THE PRODUCT HAS A NEGATIVE EFFECT.
- DO NOT USE COMMERCIAL DRYERS OR THE DRYERS AT YOUR LOCAL LAUNDRY- OMATS, AS THEY WOULD GET TOO HOT AND CAN DAMAGE THE WIRING OF THE PRODUCT.
- THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A SAFETY FEATURE. THIS PLUG WILL FIT INTO A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY INTO THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
- QUALIFIED ELECTRICIAN. DO NOT ATTEMPT TO DEFEAT THIS SAFETY FEATURE.
Storing: If the product is not to be used for a long time, please
disconnect the controller from it. It’s recommended to store in the original
packaging.
Warning: Make sure that the product has completely cooled down before
folding, otherwise it might be damaged. During storage, do not place any
objects on the folded product.
Disposing of: For the eco-friendly reason, the product should be disposed
of separately instead of being disposed of as unsorted municipal waste at the
end of its service life. Please dispose of it properly at the local waste
collection site.
WARRANTY AND CUSTOMER SUPPORT
If you need help regarding product issues, after-sales service, or other relevant problems, please contact us
FAQs
How long does it take to heat up?****
It will take about 15 minutes to heat up.
How do I turn it off?****
Press the power button for 3 seconds.
What is the difference between high and low temperature?****
High temperature is 80℃, low temperature is 60℃.
How do I clean the blanket?****
Do not use washing machine or dryer. Hand wash with cold water and mild detergent. Do not wring or twist, lay flat to dry.
What should I do if the blanket stops working?****
Check the power cord, plug and outlet for damage or loose connections. If everything looks okay, unplug your blanket for 30 seconds and then plug it back in. If it still doesn’t work, contact our support team with your product model number and Amazon order number.
Can you leave an electric blanket on all the time?****
It is not advised to leave an electric blanket on all night, even if a modern, properly cared-for model is unlikely to cause issues with correct use. Instead, it’s beneficial to warm up your bed with electric blankets before you get in and switch them off just before you go to sleep.
What size blanket is good for a twin bed?****
A twin-size blanket is 60″ x 84″ in size and is made to fit over a twin bed to keep you warm and cosy. The blanket can easily fit on a twin or twin XL mattress at these proportions. Denali offers bedding for twin, queen, and king-sized mattresses to go with your blankets.
How long should you use an electric blanket?****
Electric A licenced electrician should test blankets every two years and replace them every ten years. Always look for burn scars, water damage, mould, or exposed wires on your blanket. Do not use your blanket if it has any of these on it; instead, get a new one.
What happens if you leave your electric blanket on all night?****
Fires are the biggest danger from leaving it on for so long while you’re in a vulnerable situation. Tiny filaments that run through the blanket’s wires are prone to tearing. It’s crucial to switch it off before bed and before you leave the house because these can easily overheat and produce sparks and fire.
Can you wash an electric blanket?****
A heated blanket with wires inside can be washed. However, before washing your blanket, you must unplug the power cord (which plugs into the wall). Check the care tag to see if your blanket may be washed if the power cord is not detachable.
How do you store an electric blanket?****
When storing an electric blanket, never fold it. You can either leave it on the bed unplugged and switched off, or carefully roll it up to prevent kinking the elements and store it safely where nothing will be placed on top.
What is the point of an electric blanket?****
The heat settings are one of the most crucial factors to take into account because the primary function of an electric blanket is to keep you warm. Today’s electric blankets typically have numerous settings and considerably more advanced controls than an old-fashioned “on/off” switch.
Video
Download PDF Link;BEDSURE S-HB7284 Electric Blanket Full Twin Size
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>