GRS 003-635 Acrobat Versa Stand Instructions
- June 8, 2024
- GRS
Table of Contents
003-635 Acrobat Versa Stand
Instruction Manual
BENCH INSTALLATION
Locate the microscope stand base on the bench top so the microscope will be
over your work. Cut out the template (back cover, page 8) and tape it exactly
where the base will be located. Using a center punch or awl, mark the centers
of the screw holes through the paper and into the bench top. Remove the
template and proceed according to bench material.
WOODEN BENCH
Use a 1/8″ drill bit and drill all four holes a little more than 1″ deep.
Attach the stand to the bench with the 1-1/2″ wood screws (included).
METAL BENCH
Drill 1/4″ holes through the bench top. Use 10-32 flat head bolts (not
included) with a length of about 1/2″ more than the thickness of your bench
top to attach the stand to the bench. Bolt the stand down using washers and
nuts (not included) on the underside.
HANDLE INSTALLATION
PARTS AND TOOLS NEEDED
2 handles
2 Carriage Bolts
Wrench (not included)
STAND ADJUSTMENTS AND FEATURES
LEVER ORIENTATION
FRONT ARM ADJUSTMENT
BACK ARM ADJUSTMENT
ARM ROTATION
See GRS LIT-415 for instructions on how to mount the Leica A60 microscope with the Acrobat® Versa stand.
MICROSCOPE HEAD TILT
DOCUMENT HOLDER
CORD MANAGEMENT
Acrobat® Versa Stand
PARTS LIST • #003-635
Microscope Stand Base Template
900 Overlander Road Emporia, KS 66801 USA
800-835-3519
620-343-1084
Fax: 620-343-9640
[email protected]
www.grstools.com
Last Update: 2016-02-03