DRIVEN WH1134 Z Micro RC Recycling Truck Instruction Manual

DRIVEN WH1134 Z Micro RC Recycling Truck

R/C RECYCLING TRUCK

TO START PLAYING

1. Make sure the ON/OFF switch on the vehicle is in the ON position (Fig. 1).
   • Press on roof or right front wheel for lights and sounds.
2. Press on the vehicle’s roof, as indicated in (Fig. 2), then press any button on the remote, as indicated in (Fig. 3).
   • Press button for honk sound

TROUBLESHOOTING

NOTE: In the event that the controller and/or vehicle are not responsive, press the RESET BUTTON on the back of the remote (Fig. 4) to continue playing. If the controller and/or vehicle still fail to connect, switch the vehicle OFF and back ON again (Fig. 1). Continue with step 2. If the connection issue persists, replace the batteries in the vehicle (Fig. 1) and in the remote (Fig. 4) with new alkaline batteries. Continue with step 1 & 2.

NOTE: The vehicle will automatically go into sleep mode after 2 minutes of inactivity to save power. Wake up by pressing on the vehicle’s roof, as indicated in (Fig. 2).

Troubleshooting

REPLACING TRUCK BATTERIES

REPLACING REMOTE CONTROL BATTERIES

• Frequency bands: 2405MHz-2475MHz
• Maximum radio-frequency power: 5dbm
• Use alkaline batteries for longer playtime.
• WARNING: This toy produces ashes that may trigger epilepsy in sensitised individuals.
• WARNING!: SMALL PARTS – CHOKING HAZARD. Not suitable for children under 3 years.

WARNING
CHOKING HAZARD—Small parts. Not for children under 3 years

STEERING ALIGNMENT ADJUSTMENT
If the vehicle does not drive in a straight line, adjust the alignment using the alignment lever. If the vehicle drifts to the left, turn the lever towards the “R”. If the vehicle drifts to the right, turn the lever towards the “L”.

• Please remove all packaging materials before giving to children.

User Guide:

1. Do not use near seawater or in dirty and dusty environments.
2. Do not use in the rain or immediately after rainfall.
3. If the vehicle gets wet, open the battery compartment immediately, remove batteries, and turn the vehicle upside down to dry.
4. Always clean and dry the vehicle and remote after using outdoors to avoid damage.
5. The remote’s control distance may be reduced when using indoors.
6. The vehicle’s remote control may not work after long storage. Follow the steps below to re-start: A) Always replace the batteries in the vehicle with 3 new AAA alkaline batteries (Fig. 1). B) Follow steps 1 and 2 to start playing. C) If the vehicle does not work, put 2 new AAA alkaline batteries in the
   remote (Fig. 4). D) Follow steps 1 and 2 to start playing.

BATTERY ADVICE

Requires 3 x AAA(1.5V) batteries for the truck (included) Requires 2 x AAA(1.5V) batteries for the remote control (not included) Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Rechargeable batteries are only to be charged under adult supervision. Different types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy.The supply terminals are not to be short-circuited.

ATTENTION: When the module’s functions lose performance, follow instructions carefully to install new batteries

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>