Basement Watchdog BW-WA360 Battery Operated Water Alarm with 360 Sensing Technology Instruction Manual
- October 30, 2023
- BASEMENT WATCHDOG
Table of Contents
Basement Watchdog BW-WA360 Battery Operated Water Alarm with 360 Sensing
Technology
Product Information
The Water Alarm is a device that warns you of water leaks and potential flooding. It operates using a 9V battery and has metal pads that detect the presence of water and sound an audible alarm. The device is designed to be waterproof and can be placed in areas where water leaks are likely to occur, such as under sinks, washing machines, and water heaters. The product comes with a limited warranty from Glentronics, Inc.
Product Usage Instructions
- Using a flat-head screwdriver, remove the battery cover.
- Pull the wires out and snap the 9V battery onto the connector.
- Place the battery back in the compartment.
- To ensure waterproof closure of the battery cover, please be sure to insert the bottom of the battery cover into the unit, close the top, and tighten the screw.
- Testing the Water Alarm: After installing the battery, make sure to test the water alarm by touching any two adjacent metal pads with your fingers. An audible alarm will sound as long as you keep both fingers on the metal pads. We recommend testing the water alarm every 6 months to ensure the battery is still good, and replacing the battery as needed.
- Positioning the Water Alarm: Place the water alarm anywhere there is a risk of water leak such as under a sink, washing machine or water heater. It can be placed on any side and will still clearly sound an alarm when water is present.
- Replacing the Battery: Replace the 9V battery if the alarm has operated for an extended period of time or if the battery expiration date is approaching. You may want to mark the battery expiration date on a piece of tape and attach it to the water alarm when you install the battery.
If you have any further questions or concerns about the product, please contact Glentronics, Inc. at 800-991-0466.
The In-Touch 360˚ Water Alarm has a patented design which allows it to detect water and sound an alarm when placed on any side. If water reaches any two adjacent metal pads, located around the unit, an audible alarm sounds to alert of a leak or potential water damage. The In-Touch 360˚ Water Alarm is waterproof and can be completely submerged in water.
Installing the Battery
The In-Touch 360˚ Water Alarm is battery operated and does not need to be plugged into an outlet. You will need a Philips screwdriver, flat-head screwdriver, and a new 9V battery. Using a Philips screwdriver, remove the screw in the battery cover located on the side of the water alarm.
- Using a flat-head screwdriver, remove the battery cover.
- Pull the wires out and snap the 9V battery onto the connector.
- Place the battery back in the compartment.
To ensure waterproof closure of the battery cover, please be sure to insert the bottom of the battery cover into the unit, close the top, and tighten the screw.
Testing the Water Alarm
After installing the battery, make sure to test the water alarm by touching any two adjacent metal pads with your fingers. An audible alarm will sound as long as you keep both fingers on the metal pads. We recommend testing the water alarm every 6 months to ensure the battery is still good, and replacing the battery as needed.
Positioning the Water Alarm
The water alarm should be placed anywhere there is risk of a water leak, such
as under a sink, washing machine or water heater. It can be placed on any side
and will still clearly sound an alarm when water is present.
Replacing the Battery
Replace the 9V battery if the alarm has operated for an extended period of
time or if the battery expiration date is approaching. You may want to mark
the battery expiration date on a piece of tape and attach it to the water
alarm when you install the battery.
LIMITED WARRANTY
By opening this package and using this GLENTRONICS, INC. product, you are agreeing to be bound by the terms of the GLENTRONICS, INC. limited warranty (“warranty”) as set out below. Do not use your product until you have read the terms of the warranty. If you do not agree to the terms of the warranty, do not use the product and return it within the return period stated on your purchase receipt from the retail store or authorized distributor where you purchased it for a refund. To the extent permitted by law, this warranty and the remedies set forth are exclusive and in lieu of all other warranties, remedies and conditions, whether oral, written, statutory, express or implied. GLENTRONICS, INC. disclaims all statutory and implied warranties, including without limitation, warranties of merchantability and fitness for a particular purpose and warranties against hidden or latent defects, to the extent permitted by law. GLENTRONICS, INC. will not be liable for any incidental, special or consequential damages for breach of any express or implied warranties on this product. In so far as such warranties cannot be disclaimed, GLENTRONICS, INC. limits the duration and remedies of such warranties to the duration of this express warranty and, AT GLENTRONICS, INC.’s option, the repair or replacement services described below. Some states (countries and provinces) do not allow limitations on how long an implied warranty (or condition) may last, so the limitation described above may not apply to you. Any and all causes of action arising from, filed as a result of or in reference to, this warranty or the products described under this warranty shall be governed by and construed under the laws of the State of Illinois. Any cause of action arising from, filed as a result of or in reference to, this warranty or the products described under this warranty shall be filed only in the Circuit Court of the 18th Judicial District, Lake County, Waukegan, Illinois, or in the Northern District of Illinois if filed in Federal Court. The maximum liability for any
What is Covered by this Warranty?
GLENTRONICS, INC. warrants to the end purchaser that its Water Alarms are free
from defective materials and workmanship for the periods indicated below: All
parts and labor (excluding installation) for a period of: 5 years from the
date of purchase The defective product must be returned directly to the
factory, postage prepaid with the original bill of sale or receipt to the
address listed below. GLENTRONICS, INC., at its option, will either repair or
replace the product and return it postage prepaid.
What is NOT Covered by this Warranty?
This warranty does not cover the cost or value of damaged property, including
expressly any property that has been affected by water overflow, seepage or
flooding. If GLENTRONICS, INC. determines that a product is deemed defective
under this warranty agreement, it will repair or replace the PRODUCT ONLY.
GLENTRONICS, INC. will not cover the cost to reinstall the product, nor will
GLENTRONICS, INC. pay the cost of having a plumber or contractor repair or
replace the product. GLENTRONICS, INC. will not repair or replace a product
that was installed incorrectly. A product shall be considered “installed
incorrectly” when it deviates in any way from the instructions described in
this manual. This warranty does not cover product problems resulting from
handling liquids hotter than 104 degrees Fahrenheit, handling inflammable
liquids, solvents, strong chemicals or severe abrasive solutions; user abuse;
misuse, neglect, improper maintenance, commercial or industrial use; improper
connection or installation, damages caused by lightning strikes; excessive
surges in AC line voltage; water damage to the controller; other acts of
nature, or failure to operate in accordance with the enclosed written
instructions
How to Obtain Warranty Service
Within thirty (30) days of the product’s defective performance, the unit must
be shipped, freight prepaid, or delivered to GLENTRONICS, INC. to provide the
services described hereunder in either its original carton and inserts, or a
similar package affording an equal degree of protection. Products not received
by GLENTRONICS, INC. at the address indicated below within thirty (30) days of
the product’s defective performance will not be considered for warranty
service. Products received after above timeframe from the date of purchase,
fall outside of the timeframe for warranty service and will not be eligible
for warranty service. The product must be returned to GLENTRONICS, INC. for
inspection in order to be considered for warranty service. If the product is
not returned to GLENTRONICS, INC. or the product is inspected by any person,
plumber, contractor or business other than GLENTRONICS, INC., this warranty
shall no longer be valid. Prior to defective operation, the unit must not have
been previously altered, repaired or serviced by anyone other than
GLENTRONICS, INC., or its agent; the serial number on the unit must not have
been altered or removed; the unit must not have been subject to accident,
misuse, abuse or operated contrary to the instructions contained in the
accompanying manual. The dealer’s dated bill of sale, or installer’s invoice
must be retained as evidence of the date of purchase and to establish warranty
eligibility.
Where are Products Sent for Warranty Service?
Glentronics, Inc., 645 Heathrow Drive, Lincolnshire, IL 60069
How Can I Obtain More Information?
By calling 800-991-0466. 1806003 07/2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>