HAGOR 5760 WH Turn M Rotatable Universal Wall Mount Installation Guide
- June 8, 2024
- HAGOR
Table of Contents
HAGOR 5760 WH Turn M Rotatable Universal Wall Mount
Introduction
Caution!
Technical devices are of considerable value. You should therefore handle the
components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can
cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the
special conditions at the installation site. Please check this in advance and
replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions,
please contact us or other trained specialists.
Scope of delivery
A: Bracket | 1x
B: Tilt plates | 2x
C: Suspension bolts | 4x
D: M8x16 | 2x
E: M8x45 | 4x
F: M8x55 | 4x
G: Washer Ø 8 mm | 2x
Wall mount installation
Mount the bracket (A) on the wall (see holes marked in gray) using mounting
materials suitable for the purpose and type of wall. Check the strength of the
dowels and screws used.
Please note! The mount is shipped with the setting for clockwise
rotation. For counterclockwise rotation, remove the screw from position (R) to
position (L).
Caution! Make sure that the alignment is perfectly horizontal (X).
Suspension bolts installation
Attention!
Mounting is only possible with a centered VESA hole pattern. Adapters are
required for off-center hole patterns.
On the back of the screen, mount the suspension bolts (C) and screws (E or F) as shown in the figure above.
Disassembly of the securing bracket
Remove the safety bracket (L).
Tilt settings
Remove the screws and the washers. Assemble the 2 tilting plates (B). Fix them
with the screws and the washers.
Mount and secure the screen
Hang up the screen. Please note! Please perform this work step in pairs. Make
sure that the bolts are correctly inserted into the keyholes. Replace the
securing brackets and screw them tight.
Function test and adjustment
Try the rotation several times and make sure the screen is securely locked
with the safety brackets (L) If necessary, increase or decrease the force of
the spring by adjusting the screw (S).
Dimensions
Customer Support
Telephone: +49(0)57 31-7 55 07-0 | Mail:hagor@hagor.de]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>