Hold It Mate 00755 Powder Coated Steel Metal Garden Flag Pole Instruction Manual
- June 8, 2024
- Hold It Mate
Table of Contents
FLAG HANGING KIT FOR DECK RAILINGS
00755 Powder Coated Steel Metal Garden Flag Pole
UNIVERSAL FIT ON VERTICAL SPINDLES
Connects to PVC, metal, wood, round or square spindles from 1/2” to 1-3/4”
thick.
Typically Wrought Iron & Aluminum use the shortest bolt, PVC/Vinyl, Trex and many wood spindles will use the middle bolt. Custom wood spindles can be thicker and therefor use the longest bolt.
Included in the kit:
Prep your flag pole assembly
1a. Unscrew lag bolts from the pole mounts
1b. Lay the flat side of the keyhole rails with pole mounts onto a flat surface. Slide onto the vertical pole as shown. Line up with holes at the angle you want your flag display (see below). Reinsert lag bolts and tighten all the way (until they stop).
Install flag pole onto deck rails
2a. Choose the bolt that is just a bit longer than your spindle width
| 2b. Insert sleeve nuts into recessed holes of Rail B and loosely screw
bolts into the sleeve nuts.
| 2c. Attach both mounting rails to the pole assembly via the keyhole
slots. Let the mounting rails hang vertically.
| 2d. Bring the entire assembled flag pole with mounting rails to your
deck. Guide the vertical mounting rails through the spindles at the desired
position.
---|---|---|---
2e. Turn mounting rails horizontal and tighten sleeve nuts with Allen
wrench. Before they get too snug, adjust the mounts on both sides to be level
and balanced on the spindles, then tighten until snug.
| 2f. Cap top of pole with plug. Unscrew the wing nut at the top and
pull out the bolt (careful not to drop) – pull the flag pole up to 90˚, re-
insert the bolt and tighten with the wing nut.
NOTE: It may be easier to slide or clip your flag on while the pole is down rather than extended.| 2g. Connect grommeted flag to hooks, or slide sleeved flag over the pole.
---|---|---
Visit holditmate.com/install for a video tutorial.
WARNING: YOU, THE PURCHASER, ASSUME THE RISK OF PROPERLY USING AND MOUNTING THE HOLD IT MATE SYSTEM, INCLUDING ANY ADDITIONAL ACCESSORIES (TOGETHER, THE “PRODUCT”), TO APPROPRIATE STRUCTURES AND LOCATIONS. THE PRODUCT MUST NOT BE MOUNTED TO ANY STRUCTURE NOT RATED TO HOLD PRODUCT’S WEIGHT. This Product is sold “AS-IS” without a warranty of any kind, expressed or implied, including any warranties or conditions of merchantability and fitness for a particular purpose. In no event shall there be any liability for any direct, indirect, punitive, incidental, special, consequential or other damages arising out of or related to the use or misuse of this Product. The purchase and use of any additional accessories shall be limited to their specified use, and such use shall be subject to the warning set forth herein. If you do not accept the terms provided herein, please contact customer service at support@holditmate.com for instructions to return within 30 days from purchase or simply return where you purchased the product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>