EASY LED Bubo 2.0 B3 Bubo Lighting System Instruction Manual

EASY LED Bubo 2.0 B3 Bubo Lighting System

Bubo 2.0 B3 & B2 – Mounting instructions

Bubo weight [kg]

Bubo Aw [m2]

Installation – Mounting

Fixation Bracket detail

Use M20 bolt and washer – Tighten to 100Nm (Recommended washer according to DIN9021)
or use 2 pieces M12 bolts with washers – Tighten to 50Nm.
In case of using only one fixation point and if the luminaire is higher than 3m, the use of a 2nd fixing security system is advised.

Adjusting luminaire angle

1. After finding the right alignment
2. Tighten aim locking bolts
3. Tighten the main axle bolts

Bracket adjustment range

Bubo B1 & B1G pendant brackets

Installation – Electrical connections

BL light unit standard cable wire colors:

BG DALI and 1-10V electrical connections – example

Control circuit must be provided with cable which is insulated according to the mains voltage.

BG DMX electrical connections – example

Luminaire requires 1 address. DMX-out of the last luminaire in the chain be terminated with an 110Ω end resistor.

Closing the BG Gear unit

Use correct closing order and appropriate 2,5Nm torque

1.  Begin tightening screws from the middle of sides
2. Tighten corners next
3. Tighten the remaining screws

BGE electrical connections – examples

Notification regarding cables

• Fasten all cables to luminaire housing or bracket with zip-ties (or equivalent) to prevent movement of loose cables.
• Pay attention to sharp corners to prevent damage to cables

Suitable LED cable lengths

General

• Do not stare at the operating light source. The luminaire should be positioned so that prolonged staring into the luminaire at a closer distance is not expected. The luminaire has a built in light collimator.
• Applicable to RGB PARTY luminaire: In the lighting control standby mode (OFF), there may be a slight glow of the diodes in some installations. This is normal and does not pose a risk of damage to the luminaire or increase power consumption of the installation.
• What is condensation? It appears as small droplets of moisture inside the light. Condensation forms as gaseous moisture turns in to liquid water. It forms in the coolest parts of the luminaire, usually glass. The luminaire is designed to allow moisture to escape, but it takes time and is dependent on usage and ambient environment. Condensation does not cause a problem with normal operation of the luminaire and is not considered to be a defect.
• Any modification on the luminaire will cancel the warranty

Circuit breaker design chart

tel. +358 2 737 4420 Meriniitynkatu 11 FI-24100 Salo, Finland

References

• Easy LED - LED-valaistuksen pioneeri vuodesta 2006

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>