Crownful IM2102-UL Ice Maker Instruction Manual

Crownful IM2102-UL Ice Maker

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions:

1. Before using, check if the voltage power corresponds to the one shown on the appliance name plate or manual. This appliance only works with 120v.
2. Do not remove any safety, warning, or product information labels from your ice maker.
3. This appliance must be grounded. It is equipped with a power cord with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
4. Avoid the use of an extension cord because it may overheat and cause a risk of fire.

However, if it is necessary to use an extension cord, please do the following:

1. Use only extension cords with grounding plug.
2. The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
3. It should be positioned in such that it does not drape over the counter or tabletop where it can be pulled by children or others accidentally.
4. Do not operate any appliance with a damage cord or plug or after the appliance malfunction or has been damaged in any manner.
5. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
6. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
7. Do not let the power cord hang over the edge of the table or counter.
8. Do not place on or near a hot gas or electric burner or in a heated oven.
9. Place the power cord in such a way that it cannot be pulled by children or cause a tripping hazard.
10. Place the power cord in such a way that it is not in contact with hot surfaces.
11. The use of attachment or parts that are not recommended or sold by manufacturer may cause fire, electric shock or injury.
12. Do not touch the evaporator when using the ice maker or when making ice to avoid  frostbite or other issues.
13. Do not immerse any part of the product in water.
14. To disconnect, tum all controls to “OFF”, then remove the plug from wall outlet.
15. Do not plug or unplug product with wet hands.
16. Unplug the product before cleaning, maintaining and when not in use.
17. Do not use with water that is micro biologically unsafe or of unknown quality.
18. Do not clean your ice maker with any flammable fluids. The fumes may create a fire hazard or explosion.
19. Do not overturn the ice maker. If the ice maker is overturned accidentally, make it stand steadily for 2 hours before turning it on again.
20. If the ice maker gets cold when it is exposed outside during winter time, please allow the unit to warm up to the room temperature first, let it adjust for a few hours before operating.
21. Never put flammable, explosive and corrosive substances into the ice maker.
22. Never use the ice maker when there is a flammable gas leakage.
23. Never store or use gas and other flammable substance or devices near the ice maker to avoid any fire.
24. Unplug the ice maker before moving it to avoid damaging the refrigerating system.
25. Do not attempt to disassemble, repair, modify, or replace any parts of your product.
26. This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are given supervision, assistance or instruction concerning the use of the appliances by a person responsible for their safety.
27. Children should be supervised to ensure that they do not play with the appliance.
28. Close supervision is necessary when any appliance is used by or near children.
29. Do not leave the appliance unattended while in use.
30. Do not use outdoors.
31. Do not use the appliance for other than its intended use.
32. When disposing or recycling the unit, please dispose the ice maker properly according to the local regulations in your area as it uses flammable blowing gas and refrigerant.
33. Please check your area’s programs and local regulations regarding the  environmentally responsible way of recycling or disposing appliances with flammable refrigerant and blowing gas to ensure safety and compliance.

SAVE THESE INSTRUCTIONS

HOUSEHOLD USE ONLY

KNOW YOUR ICE MAKER

Control Panel

/”ICE FULL”/” ADD WATER” indicator light blinks rapidly; Working condition: “ICE” indicator light is solid.
ICE FULL| “ICE FULL” indicator lights up when the ice basket is full.
ADD WATER| “ADD WATER” indicator lightsup when the water reservoir lacks water.

BEFORE FIRST USE

1. Unpack the appliance, then check and make sure that all the accessories including ice basket and ice scoop etc. are complete. Please contact customer support or the seller if some accessones are m1ssmg.
2. Please ensure the ice maker is leveled on a flat surface and on a stable table or platform to avoid malfunction.
3. The inclined angle of the ice maker cabinet should not exceed 45 ° during transportation or use. Do not tum the ice maker upside down. Doing so could cause the compressor or refrigerating system to operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice maker is moved or transported. Before using the ice maker for the first time, please wait for 2 hours after the unit has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and leveled surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5°C).
7. Clean the appliance by following the instructions of “CLEANING AND MAINTENANCE” before operating the unit.

ITSTNG YOUR ICE MAKER

1. Ensure that the drain plug at the bottom of water reservoir is closed well.

2. Plug the ice maker into the wall outlet, the “ICE” indicator blinks.
   NOTE: Allow the unit to settle for 30 minutes before plugging it if it has been moved.

3. Open the top lid and remove the ice basket.

4. Fill the water reservoir with drinking water.
   NOTE: Do not fill above the MAX water level mark.

5. Put the ice basket back and close the top lid.

6. Press “ON/OFF” key, and the “ICE” indicator light will tum on (solid light).

7. The ice-making cycle will last approximately 7 -15 minutes, depending on the ambient temperature and water temperature.

8. The ice-making cycle starts with the water being pumped into the ice tray situated below the evaporator. Over the next 7 -15 minutes the ice forms on the evaporator. Once it’ s completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then formed and dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will automatically move back into position under the evaporator and starts the next cycle.

9. The “ICE FULL” indicator will light up when the ice basket is full and then the ice maker will stop the ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 7.5 seconds later, the ice maker will restart its ice making function automatically.

10. The “ADD WATER” indicator will light up when the water reservoir lacks water so the ice-making cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then press “ON/OFF” key again to restart the ice-making cycle. The appliance will start working automatically after about 20 minutes if the operator forgets to restart the appliance after refill.

11. When you finally get your desired amount of ice, stop the ice making cycle by pressing the “ON/OFF” key and unplug the unit from the wall outlet.

12. Open the top lid and transfer the ice to a freezer.

13. Allow the ice maker to reach room temperature.

14. We suggest replacing the water every week or when its quality or safety gets compromised e.g., If it has any strange color or smell. Please empty the water reservoir if the ice maker is not used for a long time.

CLEANING AND MAINTENANCE

To ensure cleanliness, quality and safety, we recommend that you clean your ice maker at least once a week.

1. Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker from the wall outlet and allow it to warm up to room temperature.

2. If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir.

3. Move the appliance forward to a place 60mm away from the working table and open the drain plug to drain out excess water (see Fig.I, Fig.2 and Fig.3).

4. Remove the ice basket.

5. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then rinse with clean water and then drain all the water.
   Remove the drain plug and return it back properly. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.

6. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap, if necessary.
   NOTE:

   • Do not use organic solvent, boiling water, detergent, strong acid and strong alkali etc. for cleaning.
   • Do not clean the evaporator.

7. Please empty the water reservoir and dry it for storage if the ice maker is not used for a long time.

TROUBLESHOOTING

TECHNICAL PARAMETERS

• Model: IM2102
• Applicable climate: ST/SN/N
• Class: I
• Power source: 120V/60Hz
• Rated current: 1.7A
• Net weight: 7.99kg
• Housing: SUS304
• Foaming agent: CsH10
• Refrigerant/Refrigerant amount: R600
• Unit size (DXWXH): 310230325mm

CUSTOMER SUPPORT

Should you encounter any issues or if you have any questions regarding your new product, feel free to contact our helpful Customer Support Team. Your satisfaction is our goal!
Email: support@crownful.com
Support Hours
Monday – Friday:
9:00 am – 5:00 pm PST

• Please have your order invoice or order number ready before contacting customer support.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>