packed party PKMC100SN Bluetooth Sing Along Microphone User Manual
- June 4, 2024
- packed party
Table of Contents
packed party PKMC100SN Bluetooth Sing Along Microphone
BUTTON FUNCTIONS
+/_
- Press to adjust volume•
- Press and hold lo turn ON/OFF
VOICE
Press to switch between Elf, Santa, or auto-tune voice-changing effects
SONG
- Press to pause/play songs during playback Press twice to skip to the next song ..
- Press and hold to turn on Bluetooth
Volume level Increases, then decreases. The microphone’s preloaded songs will not play when In Bluetooth• mode
VOICE EFFECTS
Press the VOICE button to switch between Ell, Santa or auto-tune effects
BLUETOOTH® CONNECTION
- Press and hold the SONG button to turn on Bluetooth mode.
- Enter the e1ueloolh9 settings on your Bluetooth• device, and search for “Frosty Mic:”. Tap to connect.
CHARGING
Use the included micro use cable to charge the microphone. The charging port Is located at the front of the microphone.
AUDIO RECORDING
Using the Included micro use lo 3.5mm AUX cable, connect the microphone to your mobile device.
On your mobile device, open a song recording app of your choice and start
recording. Select the song you wish to record and play ii through the
microphone. Once finished, go back to your song recording app and stop
recording.
NOTE: The audio recording function Is compatible with Androfd’T’M
devices. Applen• users need to use an Apple,1 competiable coble or adopter for
recording (sold
separately).
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed lo provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. The Bluetooth® trademarks-including the BLUETOOTH word mark, the figure mark (the runic “B and oval design), and the combination mark (Bluetooth word mark and design)-are owned by the Bluetooth SIG. USB is used to solely describe the compatibility of our technology and in no way is intended to infringe on any intellectual property rights of any respective protected marks.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>