Joy-IT PRO MICRO Arduino Compatible Microcontroller User Manual
- June 8, 2024
- JOY-It
Table of Contents
PRO MICRO
Arduino Compatible Microcontroller
User Manual
GENERAL INFORMATION
Dear customer,
thank you very much for choosing our product.
In following, we will introduce you to what to observe while starting up and
using this product.
Should you encounter any unexpected problems during use, please do not
hesitate to contact us.
PINOUT
By closing the solder bridge J1, the voltage converter on the board is
bypassed and the board is directly supplied via the microUSB voltage or the
VCC pin. This also allows the operation from as low as 2.7 V.
The logic level of the module then also corresponds to the supply voltage.
Attention!!! With closed solder bridge the module may only be supplied
with max. 5.5 V!!!
SETUP OF THE DEVELOPMENT ENVIRONMENT
To program your Pro Micro you can use the Arduino IDE.
which you can download here.
Now you can set your development environment, for this select under Tools ->
Board -> Arduino AVR Boards -> Arduino Micro.
Finally, you need to set the correct port to which your Pro Micro
is connected.
You can select this under Tools -> Port.
CODE EXAMPLE
Now you can copy the following sample code into your IDE and upload it to your
your Pro Micro.
The program makes the two built-in LEDs on the RX and TX line blink
alternately.
ADDITIONAL INFORMATION
Our information and take-back obligations according to the Electrical and
Electronic Equipment Act (ElektroG)
Symbol on electrical and electronic equipment:
This crossed-out dustbin means that electrical and electronic appliances do
not belong in the household waste. You must return the old appliances to a
collection point. Before handing over waste batteries and accumulators that
are not enclosed by waste equipment must be separated from it.
Return options:
As an end user, you can return your old device (which essentially fulfils the
same function as the new device purchased from us) free of charge for disposal
when you purchase a new device.
Small appliances with no external dimensions greater than 25 cm can be
disposed of in normal household quantities independently of the purchase of a
new appliance. Possibility of return at our company location during opening
hours:
SIMAC Electronics GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn, Germany
Possibility of return in your area:
We will send you a parcel stamp with which you can return the device to us
free of charge. Please contact us by email at Service@joy-
it.net or by telephone.
Information on packaging: If you do not have suitable packaging material
or do not wish to use your own, please contact us and we will send you
suitable packaging.
SUPPORT
If there are still any issues pending or problems arising after your purchase,
we will support you by e-mail, telephone and with our ticket support system.
Email: service@joy-it.net
Ticket system: http://support.joy-it.net
Telephone: +49 (0)2845 9360-50 (10-17 o‘clock)
For further information please visit our website: www.joy-it.net
Published: 27.06.2022
www.joy-it.net
SIMAC Electronics GmbH
Pascalstr. 8, 47506 Neukirchen-Vluyn
Pascalstr. 8 47506 Neukirchen-Vluyn
References
- ITnet | Servizi di Colocation e Cloud
- Joy-IT Helpdesk
- For Makers and Professionals | Joy-IT
- Software | Arduino
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>