SENSIRION SFC6000 Mass Flow Controller Kit User Guide
- June 9, 2024
- SENSIRION
Table of Contents
SFC6000 Mass Flow Controller Kit
User Guide
SFC6000
Quick start guide
for mass flow controller kit
SFC6000 Mass Flow Controller Kit
Welcome
This quick start guide will help you in evaluating SFC6000 in just a few
simple steps.
All you need is a SFC6000, a PC, a pressurized gas source and the evaluation
kit for SFC6000 (sold separately).
Please visit our website for more information on the SFC6000, including the
required software: www.sensirion.com/
Set-up
- Install the latest version of “ControlCenter” software. https://sensirion.com/products/sensor-evaluation/control-center/
- Connect the SFC6000 in the direction indicated by the arrow to a pressurized gas source. For your first test, the outlet can stay unconnected.
- Connect the two DB9 cables together and the one cable with a round end to SFC6000.
- Connect the USB part of the cable to your PC and the power adapter to an electric source.
Overview of Sensirion ControlCenter
- Start the Sensirion ControlCenter application.
- SFC6xxx should be listed in the sensor window. If it is not listed, the set-up is most likely incorrect and should be reviewed.
- Pressing the wheel symbol opens the configuration window.
- In the configuration window choose the right gas calibration and hit “Done”.
- To start the measurement press “Start”
Controlling Gas Flow
- Launch the ControlCenter and make sure SFC6000 is connected.
- Press “Start” to begin the recording of the measurement.
- Open the configuration window and specify the desired set point.
- Press “Apply” and hit “Done”.
- Configure the set point to be 0 and press “Stop” to end the evaluation.
Note: You need to configure set point to 0, in order to close the valve, else it will remain open.
Thank you for your interest in our mass flow controller solutions.
Sensirion AG
Laubisrütistrasse 50 · 8712 Stäfa
Switzerland
phone +41 44 306 40 00
[email protected]
www.sensirion.com
References
Read User Manual Online (PDF format)
Loading......