PHILIPS BR30 Bluetooth 85W Smart LED Bulb User Manual

PHILIPS BR30 Bluetooth 85W Smart LED Bulb

Instruction

please go to www.philips-hue.com to learn more about Hue and how to use It
This device complies w1th Part 15 of the FCC Rules and w1th RSS of Industry Canada Operation its subject to the following two conditions:

1. This device may not cause harmful Interference, and
2. The device must accept any Interference received, Including Interference that may cause undes1red operation.

The advanced Interface module complies w1th FCC radiation exposure ltm1ts set forth for an uncontrolled environment
This equipment should be Installed and operated w1th minimum distance of a• or 20cm between the radiator and your body.

IMPORTANT   NOTE: accessories such as Hue Bridge, Hue Smart Button. Hue Smart Plug, Hue Dimmer Switch, Hue Motion Sensor and Hue Tap dial sw1tch: this Class B digitat apparatus complies w1th Canadian ICES-003.

IMPORTANT NOTE BUbLBS This Class B digital apparatus complies with CAN ICES-005 (B) / NMB-005 (8).
This digital apparatus does not exceed the class B limits for radio-noise emissions from digital apparatus as set out tn the Radio Interference Re11utat1ons of the Canadian Department of Communications.

NOTICE: Changes or modifications made to this device not expressly approved by Signify North America Corporation (“Slgnlfy1 may void the U.S. FCC and Canadian authorization to operate this device.
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful Interference 1n a residential Installation.
This device generates, uses. and can radiate radio frequency energy and, If not Installed and used In accordance with the Instructions, may cause harmful Interference to radio communications.

However. there 1s no guarantee that Interference will not occur In a particular Installation If this equipment does cause harmful Interference to radio or television reception, which can be determined by turntn11 the equipment off and on, the user Is encouraged to try to correct the Interference by one or more of the following measures

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
•  If applicable. connect the equipment Into an outlet on a circuit different from that to which the receiver Is connected
• Consult the dealer or an experienced radio/television technician for help

LIMITED WARRANTY

Signify warrants that this device’s hardware components w1ll be free from defects In material and workmanship for a period of two (2) years from the date of purchase. unless a different period Is stated In or on the packaging of the product, based on up to 3 hours average working time per day/7 days per week, when used as directed (the “Warranty Period”) Notwithstanding the foregoing, the Warranty Period for all Energy Star-certified products Is three (3) years from the date of purchase. This limited warranty only applies to the hardware components contained in the original packaging. This limited warranty does not apply to any software, even  packaged or sold with the hardware components. Signify does not warrant that use of this device will be uninterrupted or error-free. If this device does not conform to this limited warranty, Sfsnlfy will send you, at its elect1on, a replacement device or refund your Or11illnal pr1ce upon receipt of the returned device, re81ster receipt and proof of purchase. Please call our toll-free number, 1-800-555-0050, or write to us (address Indicated on the packaging) to find out how to return the deV1ce. This limited warranty does not cover deV1ces subject to accident, nelillect, abuse, misuse or acts of God REPLACEMENT OR REFUND IS YOUR SOLE REMEDY EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSELY EXCLUDED. Some states and provinces do not allow exclusion of Incidental or consequential damages, so the above limitation or exclus1on may not apply to you. This limited warranty you specific and you may also have other r1ghts which vary from state to state and province to province. This limited warranty Is subject to, and may be superseded by, our End of Support policy to the extent Signify decides to terminate support for this device in accordance with Its End of Support policy, available here:
www.philips-hue.com/endofsupportpoltcy

WARNINGS AND CAUTIONS
This product is not a toy designed to be played w1th by children.
Keep away from young children
Do not place on hot surfaces.
Do not place on a thick rug or carpet
For safety reasons and under the terms of the warranty, none of the enclosed devices should be opened.

caution· do not use this bulb (E26 base) In a 3 way lamp socket (E26d)

WARNINGS AND CAUTIONS FOR Hue indoor products
The Indoor product Is for Indoor use only. Do not use In a wet location, areas directly exposed to water or outdoors.
Keep away from liquids and humidity.

WARNINGS AND CAUTIONS FOR Hue outdoor Bulbs
Use the product only in a fixture suitable for wet locations.
The cap of the bulb not suitable to be exposed to water nor wet conditions.

WARNINGS AND CAUTIONS FOR PRODUCTS USING B.ATTERIES·
Risk of explosion If the battery Is replaced by an Incorrect type.
Batteries should be Installed by an adult
Different types of batter1es and new and used batteries must not be mixed.

• Batteries are to be inserted with the correct polarity.
• The supply terminals must not be short-circuited.
• Exhausted batteries are to be removed from the product
• Do not use rechargeable batteries.
• Non-rechargeable batteries must not be charged.
• Disposal of your old product:
• Manase in accordance with disposal laws 1n your area
• Remove the batteries when you discard the product. Do not throw the batteries away with normal household waste. They must be handed in at an official collection point or at a Phillps Dealer, both of which will dispose of the batteries In an environmentally friendly way.

EXTRA WARNINGS AND CAUTIONS FOR PRODUCTS USING COIN/BUTTON BATTERIES:
CAUTION: Do not Ingest battery – Chemical burn hazard
Keep new and used batteries away from children.
If the coin/button cell battery Is swallowed, It can cause severe internal burns In just two hours and can lead to death.
If you think that batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
If the battery compartment does not close securely, stop using the product and keep It away from children.

WIRELESS SPECIFICATIONS

• Wireless RF mode frequency band: 2,400-2,483.5 MHz
• Operating channels Zlgbee 1f applicable: channels 11 – 26
• Operating channels Bluetooth if applicable : channels 0-39
• Maximum transmitted power <20 dBm

EXTRA WIRELESS SPECIFICATIONS for Hue Dimmer switch, Hue Smart button, Hue motion sensor and Hue Tap dial switch

• Range: 12 m indoor
• Installing on or near metal surfaces may lead to reduced range.

ENVIRONMENTAL SPECIFICATIONS FOR ALL Phtltps Hue PRODUCTS Temperature (operation); 32 … 104°F {0 … 40 °C)

• Temperature (storage): -40 … 176°F (-40 … 80 °C)
• Relative humidity (operation): 0-80%
• Relative humidity (storage): 0-90%

EXTRA ENVIRONMENTAL SPECIFICATIONS for Hue Bulbs

• Temperature (operation): -4 … 113.F (-20 … 45 ·q
• Temperature (storase): -13 … 140.F(-25 … 60 “C)
• Relative humidity: 5-95% non-condensing

EXTRA ENVIRONMENTAL SPECIFICATIONS for Hue Smart Plug

• Temperature (storage). -4 … 158°F (-20 70 ‘C)
• Relative humidity: 5-95% non-condenslna
• Type 1 enclosure
• Pollution degree 2
• Operating Control:
• Type 1.B action
• Standby power: <0.5W per device

EXTRA ENVIRONMENTAL SPECIFICATIONS for “Hue Motion Sensor Outdoor”

• Temperature (operation): -20-S0°C.
• Motion-sensing functionality is reduced at temperatures > 30•c

ADDITIONAL PRODUCT SPECIFICATIONS Hue Dimmer Switch. Hue Smart Button and Hue Tap dial switch
Wall plate installation
Always switch of power prior to Installation
If  doubt. consult a qualified or licensed electrician
Ensure the product Is always Installed according to relevant regulations. Perchlorate Material-special handling may apply.

ADDTIONAL PRODUCT SPECIFICATIONS for Hue Smart Plua
The equipment must be connected to a  socket outlet with a protective earthing connection.
Before replacing, tum off power and unplug the appliance connected to the device Do not exceed the maximum load as Indicated on the product
The product is designed to switch on and off light sources. We recommend not to connect other appliances to the plug.
Do not connect any Hue lamp to the product.
Do not connect multiple devices one after the other.

ADDITIONAL PRODUCT SPECIFICATIONS “Hue Motion Sensor Indoor” and “Hue Motion Sensor Outdoor”

• Features of automatic action : Type 1 action
• Impulse voltage: TIV

ADDITIONAL PRODUCT SPECIFICATIONS “Hue Motion Sensor Outdoor”

• Suitable for general outdoor use
• Do not submerge In water

CLEANING AND MAINTENANCE:

Do not clean the device when It Is on and connected to the power supply. To avoid scratching the device, clean only with a soft dry cloth.
Do not use cleaning aaents to clean the device.
Manage in accordance with d1sposal laws fn your area.
The Bluetooth® word marl< and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Signify ts under license. Other trademarks and trade names are those of thetr respective owners.
Hue Personal Wireless Lighting Is a trademark owned by Standby Holtan B.V.
Philips and the Philips shield emblem are registered trademarks of Konlnklljke Phelps N.V.

CUSTOMER SUPPORT

For more Information, please visit our website at
www.philips-hue.com/support, or call our customer service (1-800-555-0050)

Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater. NJ 08807, USA
Signify Canada Ltd./S1grnfy Canada Ltee.
281 Hillmount Road.
Markham, ON, Canada L6C 2S3
Questions or Comments /
Questions ou commentalres:
1-800-555-0050
lmportado y/o distribuldo en Mexico por:
Signify Mexico S.A. de C.V.
Av. La Palma N° 6-Col. San Fernando,
La Herradura Huixquilucan
Edo. De Mexico, C.P. 52784 – R.F.C. PME-620620-E84
Centro de contacto:
01-800-508-9000 www.phillps- hue.com
© 2022 Signify Holding
All rights reserved
3222 639 07752
Last update: 01/2022

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>