ALTA Roller Skyline Shades Installation Guide
- June 9, 2024
- ALTA
Table of Contents
ALTA Roller Skyline Shades
INSTALLATION INSTRUCTIONS
Important: Make sure the mounting surface is level. Brackets must be in line and level for shade to operate properly. Shim brackets if necessary.
Pre-Drill Pocket Profile
Using a pencil, mark the screw hole locations. Use a center punch on the marked locations. Pre-drill mounting screw using a 1/8” drill bit. Insert Bracket into pocket (may need mallet to gently tap bracket into place) until flush with end of pocket. Secure the end plates into the pocket using the provided screws.
Install the Pocket – Celling Mount Only
Respecting the pre-drilled holes, mount pocket to ceiling using the
appropriate mounting screws.
Important: Secure bracket to pocket/celling with supplied mounting
screws.
Install the Shade
Important : Please see AgileLift section before installing AglieLift
Shades.
First, place the spring loaded pin end into the round hole of the bracket.
Then, keeping the pin end secure in its bracket, insert the hooks on the
clutch or motor head straight into the two slots in the bracket. Once the two
hooks are through the slots, gently pull downward on the side with hooks until
the hooks have locked securely to the bracket. The bottom of the clutch or the
reset but-ton on the motor should point straight down.
AgileLift
Important: Do not to pull the lock pin until shade is securely assembled
onto the brackets.
First, follow steps to Install the Shade. Lastly, remove the lock pin prior to
operation by pulling it down.
Note: If for any reason needs to make an adjustment on the position of the installation brackets or remove the shade; raised the shade and insert the lock pin prior to disengaging the shade from the installation brackets.
Installing and Removing the Bottom Closure
To install, insert the bottom closure into a pocket on an
angle, and hook it onto the front side of the pocket. Once it is aligned,
carefully allow front of bottom closure to drop in place.
To remove, carefully raise the front of the bottom closure until the hook
disengages from the pocket. Then, rotate the bottom closure and slowly remove
it from the shade.
Remove the Shade (Only If Necessary)
First, follow the steps to remove the bottom closure. Then, gently lift the control unit (hooks end) to disengage, until the hooks touch the top part of the bracket slot. Pull the shade towards the spring-loaded pin end until the hooks are completely out of the bracket slots. Finally, remove the spring- loaded pin end from the Idler bracket.
Important: For Agilelift shades, raise the shade and insert the lock pin prior to disengaging the shade from the installation brackets.
Child Safety
WARNING: STRANGULATION HAZARD
Young children can be strangled by cords.
Immediately remove this product if a cord longer than 22 cm or a loop
exceeding 44 cm around becomes accessible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>